Hello!We are currently using the STSPIN32G4 microcontroller for our project, which incorporates a quadrature encoder.In the start-up parameters, there are three key settings: Duration, Alignment Electrical Angle of Id, and Final Current Ramp value. ...
Hello.I am using a Nucleo-F446RE board with the x-nucleo-ihm07m1 driver, to control a LA052-040E servomotor.Comment that I have not been able to generate the motor profile with the ST Motor Pilot Tool (profiler) V1.2.9.Which comes with the MotorContr...
Our project uses an external ADC reference voltage of 3.03V.This value is properly set up inside the json I use to generate the inital project code ("amplifyingNetworkVm": 3.03, "polarizationOffset": 1.515).Now I found in the generated code that insi...
Hello,For our application, we have developed a brushless motor driver 1.5KW based on the EVSPIN32G4 circuit board.We use a brushless drone motor with 14 pairs of poles (https://store.tmotor.com/goods-922-V605+KV210.html). I use MC workbench 6.2.1 for...
Hello STM32 Community,I am currently working on a customized controller board with the same architecture as the EVSPIN32G4-dual, using the STSPIN32G4 and STDrive101, to control two BLDC motors. However, I have encountered a few issues and would appre...
Hello, I am trying to use STM32 Motor Control Workbench(which I downloaded from the material of Motor control part 5 package) to control a BLDC motor with FOC. The motor I have is a custom one, the control board and power board are going to be custom...
Hi all, I have been trying to control my BLDC motor with an condition where if the surrounding temperature increases a threshold temperature the bldc motor should turn fast else slow. I am using lm35 as temperature sensor, i was able to interface thi...
Hello! I'm trying to configure the following setup to run the motor profiler in order to characterize a set of small/low-power BLDC motors. Configuration:I'm using MCWB 6.21Control board: Nucleo F401RE in the following configuration:JP5 at U5V,JP1 OF...
Hello,i am trying to run the Evalkit-Robot-1 example project. unfortunately i get the error "configuration files cannot be found in 'MCSDK_v5.4.4/MotorControl'. This version is no longer available for download. Is there an updated version of the exam...
Hey everyone!I was just exploring different features of the ST MCSDK and encountered the on-the-fly startup option dedicated to fan application.Whenever I check this option, after the startup procedure, the motor accelerates to its nominal speed and ...