What kind of throughput is achievable with USBX and CDC_ACM using the HS USB peripheral of the STM32U5A5ZJ? Im guessing its no where near the 480 Mbps. Any tips on getting this data out at the maximum rate and without dropping data?
Hi,I have Nucleo-H743ZI2 and Nucleo-U575-Q boards.I can see that we can upgrade the st-link firmware for STM32 boards via STM32CubeProgrammer, ST-LINK Utility or STSW-Link007 tool. But I have observed that this will always pick up the latest version ...
Hello,I try to build a 'PDO SINK' project on B-U585I-IOT02A and I have watched the video How to build an USBPD Sink application using the X-Cube-TCPP software pack - YouTube.Issue:After build project on STM32CubeMX 6.12.0 and opened project in STM32C...
Hello everyone. I am currently learning by working on a project in which I have to establish a SPI communication between a Nucleo U575ZI-Q and a STEVAL-MKI168V1 (IIS2DH eval board). To set up the Nucleo board and its peripherals, I used the STM32Cube...
Hello,I've successfully used the code below to enter shutdown on a U585CIUx. It wakes up on button press and I can tell it is coming up from reset because of timestamps (based on time since startup) and terminal output that only happens during startu...
Dear, I want to use SMPS of STM32 using this schematic Can you review this if i'm correct ? Thank you
We are looking to work with the STM32U5A9J-DK Discovery kit, which features the STM32U5A9NJH6Q MCU. Our application requires the use of the Octal SPI flash memory in a FreeRTOS environment. Specifically, we need to perform simultaneous read and write...
I have been trying to run the IOT_HTTP_WebServer Demo on the B-U585I-IOT02A board, and the program seems to get stuck in an infinite loop. It will enter the app_entry() function and then reach the the line that contains if (webserver_wifi_connect() !...
Hi,I making a product that has the STM32U5 running from a battery, most of the time being in one of the low power modes. I can use the debugger to .. debug my code, step through it, use SWO etc, and this all works great. However, as long as the debug...
Hi,I'm willing to use the MXCHIP EMW3080B wireless module on the B-U585I-IOT02A in a project with TrustZone enabled. As there is no tutorial for that, I copied files from the Nx_Network_Basics example.Unfortunately I get the following error when buil...
