Hi, I have about half year experience now with STM32H750 hardware, and all working very nice now. Up to now I always had used Revsion Y chips.Now on the last order we got Revision V chips (LQFP100 housing, chip marking line 1: "STM32H750", line 2: "V...
Hi EveryoneI am trying to view variables in Keil MDK5 Logic Analyzer Window therefore I have enabled trace and do the required settings of my STM32F429I discovery board. But When I open Debug window and run my code I get trace: No Synchronization mes...
I've connected SWDIO, SWDCLK, TRACESWO and NRST to the ST-LINKV2, but have no luck with trace functions. There is also a "Trace - no synchronization" message.Is there anything else I should be doing ?
Hello All,I am using STM32F030C8, with ST-LINK V2 debugger & Keil V5 IDE.While working on my application, I found two cases, where some logic / functionalities works properly only if we are using debug session. Else, those functionalities doesn't wor...
Hello Im using STM32F303K8T6 controller...Im flashing my code from keil using ST-Link...I can't put my controller in debug mode...It directly goes to run mode...hardware reset is also not working... please help me
A remote co-worker has this problem with Keil 2.56.2 and white ST-LINK/V2 dongle.Our setup is same, for me the trace and ITM works fine. The "Trace: no synchronization" message sometimes shows up but usually quickly disappears.For him, it stays and w...
I'm attempting to program a blue pill stm32 but I'm plagued with software issues/errors and im in need of some advice/help. The issue is with the st-link v2 working in tandem with keil. It only works for the first time a try to flash the board and no...
Posted on December 26, 2017 at 20:23So I made a custom STM32F446RET6 board and I first used a mini ST_LINK programmer to connect to the MCU. I was able to program it but couldn�t debug it since the mini ST_LINK programmer doesn't have the SWO pin. I...
Posted on September 16, 2017 at 13:25Greetings People,I am trying to program my target device STM32F030R8 using Discovery F0 Board. I have removed CN2 jumpers and connected my target device to CN3 pins♯ 1,2,3,4,5. I have left out pin 6 which is not ...
Posted on May 25, 2015 at 02:16Hi, I'm using an STM32F302R8 board to do some basic DSP work. I've been using my desktop with windows 7 on it for a while and I'm able to use Keil V5.14 to program the board no problem. However, I have to move to using...