Hi, Am trying to flash the program in STM32CubeIde Using ST-link V2 Debugger, but am getting the error "Error initializing the St-Link debugger" and "Target Not Found". Kindly help me to solve this issue. I have tried through programmer also but no ...
We are using STM32L476ZGTx. Until recently I was able to program the chip using ST-Link. A few hours back programming failed due to power issue and since then I have been unable to program the controller.The device connects with ST-Link Utility every...
I have been flashing to my custom board that has STM32G474 MCU. But once when I tried to set the BFB2 bit manually using ST Link utility (while keeping nSWBOOT0 reset, and nBOOT0 set), the device is now no more programmable. The device is still detec...
Hi all,In STM32L151RDT6, it is initially set to BOR4 (Brown-out reset threshold 4), but I want to run this at 1.8V in the system. Is there any way to launch this at 1.8V and rewrite the BOR level? The solution to this problem can be some HW modifica...
The board was working fine and then after some time i tried to connect again to flash via CUBE IDE but it didn't connect. I am getting the following error when i try to connect using STM32 CUBE PROGRAMMER.i am able to get EVA_H757XI mass storage when...
Hi, Everyone,I am developing the standalone SWD programmer operating by battery.I have a problem to program flash thru SWD directly.So, I traced SWD line with the ST-Link Utility. It looks that some tiny flash program code and updated user firmware a...
- Keil MDK5 v5.31 - STM32H743- Nucleo-144 board- STlink Firmware: STM32 Debug+Mass storage+VCP V2.J35.M26Bank 0 Sector 0 and 1 I can view in the memory windowsBank 0 Sectors 2 through 7, as well as all as Bank 1, show up as 0xFF, i.e. I can't view th...
Hello.I made big board with STM32H743XI, and it works without glitch. Since STM32H747 is pin to pin compatible (TFBA240+40) I modified PCB that it will fit both processors. ( just a single ground was needed for SMPS, but i don't use it,)For some reas...
I wrote a lib to handle different routine that read/write the flash. Everything works fine.The linker file is customized with some page declarations later use to affect some variables to some flash area.I have done all the debug using the embedded ST...
Hey,I try to implement an update mechanism by using the dual-bank boot mechanism of the STM32L475RC. In general the bank swapping works, but sometimes, when I remove the power supply in the wrong moment during the OptionByte-Launching, the microcontr...
