Hi All,I made a piece of hardware, where I use STM32G0B1CET6N as a supervisor for another CPU (Qualcomm CPU+LTE) and to manage USB ports/ battery charger.All went well until I started to add to my code USBPD and USB CDC (virtual COM port).I was look...
I am unable to configure TCPP03-M20 USB power controller chip available on B-U585I-IOT02A board.Supposedly, unlike most other boards, this board should be able to provide power to a device over USB-C connector.However, I found no examples of how to p...
Hello! I am trying to build a simple project on STM32G431KBTx featuring USB PD.I am using STM32CubeMX (latest version), all libraries, etc. are also of latest revisions. I've setup USB PD parameters via GUI, and generated code for Makefile.When I cal...
STM32CubeMon-UCPD 1.3.0 does not show any connected board (NUCLEO-G0B1RE + X-NUCLEO-SNK1M1).I followed the intruction in AN5418(ver.5) and the corresponding Youtube video.There are no errors when building the code and flashing it to the board.But the...
Hi,i tried the SAI_AudioPlayback example for the h745 discovery board. I'm using Keil and with the keil 5 armcc compiler everything works fine.Now i switched to armclang 6 and replaced the "libPDMFilter_cm7_keil_wc16.lib" with "libPDMFilter_cm7_gcc_w...
Dear All,I'm looking for self diagnostic feature in STM32F7 series for SIL-3 compatibility, kindly suggestion microcontroller which can self diagnosable crystal clock ,ECC protected sram and flash memory . and also let me know The HAL library is SIL-...
Hi, my company is pursuing a UL1998 (very similar to IEC 60730-1) Functional Safety Certification. In reading the ST Application Note (AN4435) I see in section 3.3 SRAM Tests, it says "Some ST Microcontrollers feature a built-in word protection with...
Hi! I have followed the tutorial on Youtube.•STM32L4 training: 07.3 Advanced peripherals - Hands-on DFSDM(L476) Now I have data in playbuff, and I use uart to collect data by COM port. However, I want to inquire some parameter in this DFSDM result, s...
Hello Community,I am using the driver L99DZ100GP as SBC in one of our projects. We have configured SBC as CAN Wakeup Capable while keeping the ECU to sleep. While testing we have observed that CAN ID 0x522 is not able to wakeup ECU. Note : 1. We have...
Team,i'm trying to store data - by use of HAL lib - during Hardware,Memory.. and so on Fault Interrupt routine. Idea is to write some data at the very end of flash - allowable area. So, the code is tested druing normal operation. However, placed in H...