Ask questions and find answers on STM32Cube packages, including HAL, LL and middleware, and expansion software.
I tried to configure the MCU as a mass storage device using Cubemx without success. The board was connected to the computer with CN1 and CN2 at the same time.I confirmed that the short was caused by U4 by removing it. After removal of U4 the current ...
For example, I can go here, and grab the STM32F2 System View Description, which is a zip file containing release notes and two svd files.However, there is no license on these files, either as a separate file in the zip or embedded in the svd. It woul...
I have Timer4 configured as a OC timer, the trigger Out event should trigger every rising and falling edge the ADC1 to read 4 channels (CH1-CH4). The trigger event to the ADC runs, when I don't use the DMA. I tried to use the Interrupt function with ...
I've been looking into STM32Cube_FW_L4_V1.15.0 and I can't found any.Thanks in advance
I am trying to program a USB HID example but when I have uploaded to debug Windows will not recognise the USB device correctly.The windows USB device viewer tool reports the following:-*****************************************************************...
I am using STM32F0 microcontroller for my project with MPU6050. The HAL driver i2c code is working fine for mpu6050 but LL driver code doens't work. I want to use LL driver for i2c. Following is my LL driver code for reading and writing.uint8_t motio...
I have designed and build a PCB with an STM32F4 and an Micro SD card slot reader on it. It has happened to me that multiple times the board works for a while and then it either burns out the STM or damages the SD card, My problem only occur when an ...
I want to test out the DFU on STM32F429ZI-NucleoI have located the Boot loader project.STM32F429ZI-Nucleo\Applications\USB_Device\DFU_StandaloneIn order to have this Bootloader Jump into the App. Do I simply change the FLASH (rx) : ORIGIN = 0x...
I've tried numerous of configurations, initialized pins in different modes, but CAN doesn't reach IRQ handler...it should work after "HAL_CAN_ActivateNotification(&hcan1, CAN_IT_RX_FIFO0_MSG_PENDING)" according to library documentation....the driver ...
Hi,In one of my task, i just increment a one seconds counter variable after read HAL_RTC_GetTime and compare the read seconds value is change or not. It doesn't work until I comment the following line in the HAL_RTC_GetTime function as described in...
