Ask questions and find answers on STM32Cube packages, including HAL, LL and middleware, and expansion software.
Dear STM32 Community, We believe that the example projects provided for the STM32Cube embedded software are a valuable resource when developing projects. We would like to better understand how developers use these examples in their workflow and e...
The ST link on the board creates a virtual com port, conected to the LPUSART1 of the micro L4A6ZG.What I´m trying to do is to program the micro throught this com port. To do this, I try this sequence:Put boot0 to high, by shortcircuiting pins 5-7 of...
Hi everybody,I have a weird problem with my STM32F302CC;In my project, HSE can work properly without USB is configured. But when I configure USB, things get weird.In debug mode, the program crash in SystemClock_Config() function when it reaches to ;i...
Hi, I'm not sure if this is the right spot for this question, but here goes. I've just migrated from CMSIS v1 to v2. One of the changes to the API was thread creation. The stack size is now specified in bytes instead of DWORDs. The size is simply di...
The transmit command only clocks out the provided data and then the clock stops, I need it to continue for 8 dummy clocks before doing receive I think.I bet there is a simple answer to this though, can you help me?
I just activated LwIP and MBEDTLS over my STM32F427 project, just after migrating it to STM32Cube_FW_F4_V1.25.1 software version, and after code generation I get a compilation error (no customization at all):Middlewares/Third_Party/LwIP/src/apps/snmp...
how can i interface the sd driver using spi , made for user_diskio.c only to run with usbd_storage_if.cThe function used by user_diskio.c for read and writeDRESULT USER_read ( BYTE pdrv, /* Physical drive nmuber to identify the drive */ BYTE...
I am testing the above setup using an transcend micro sd card adapter with 16GB sd card.I have no response from the sd card , i have used 32MHz clock with a spi baud rate 8MBits/s.i have used drivers from STM32Cube_FW_L0_V1.11.2\Drivers\BSP\Adafruit...
I'm using STM32F767ZI MCU based Nucleo -F767ZI development board, which is supporting Ethernet communication protocol and so on. I have a motor driver which is supporting the EtherCAT communication interface, and I want to interface that motor driver...
Hi all,I am using STM32F429AG for one of our project. When i use vector table at its default position USB virtual com port works perfectly. However, when i relocate the Vector table, my windows pc gives error that the USB device is malfunctioning. Ot...
Im trying to use rftt_q15 from CMSIS DSP libraries on my STM32F767ZiThe following error I get is quite strange. it says #error "Define according the used Cortex core ARM_MATH_CM7, ARM_MATH_CM4, ARM_MATH_CM3, ARM_MATH_CM0PLUS, ARM_MATH_CM0, ARM_MATH_A...
