Ask questions and find answers on STM32Cube packages, including HAL, LL and middleware, and expansion software.
I am testing the above setup using an transcend micro sd card adapter with 16GB sd card.I have no response from the sd card , i have used 32MHz clock with a spi baud rate 8MBits/s.i have used drivers from STM32Cube_FW_L0_V1.11.2\Drivers\BSP\Adafruit...
I'm using STM32F767ZI MCU based Nucleo -F767ZI development board, which is supporting Ethernet communication protocol and so on. I have a motor driver which is supporting the EtherCAT communication interface, and I want to interface that motor driver...
Hi all,I am using STM32F429AG for one of our project. When i use vector table at its default position USB virtual com port works perfectly. However, when i relocate the Vector table, my windows pc gives error that the USB device is malfunctioning. Ot...
Im trying to use rftt_q15 from CMSIS DSP libraries on my STM32F767ZiThe following error I get is quite strange. it says #error "Define according the used Cortex core ARM_MATH_CM7, ARM_MATH_CM4, ARM_MATH_CM3, ARM_MATH_CM0PLUS, ARM_MATH_CM0, ARM_MATH_A...
Hi! I am trying to set ADC pre-scaler of my STM32G431KB however no matter what I do it never changes from 0x0.I can setup ADC1 register without a problem but when it comes to ADC12_Common register nothing seems to be configurable. Below there is my A...
I was wondering why the library function LL_I2C_HandleTransfer is not available in th F4 LL library?
Hi :) This is related to my other post (https://community.st.com/s/question/0D53W00000EcBvNSAV/sai-no-signal-on-mclk-pin) but I thought it would be more organised to make two posts since the question is different.How do I get the best audio clock acc...
UM1725, the HAL User Manual, mentions the function HAL_RTC_SetWakeUpTimer() in one place in passing, and nowhere is it described.Where are the doc's for this function (and related)?Thanks,Dave
Hi all,We are using the en.stm32_f105-07_f2_f4_usb-host-device_lib_2.2.0 library for CDC functionality. Our STM32 ist USB device connected with host. Everything working fine till the host gets HW reset. Then sometimes after host booted again the STM3...
I am working on STM32H7 mcu. I have 14000 bytes of data and I am sending it over Ethernet in packets of size 1400 each. I want to transfer these 14000 bytes in only 45 µsec which I am unable to because i had to wait for each packet sent. How can I du...
