Ask questions and find answers on STM32Cube packages, including HAL, LL and middleware, and expansion software.
Hi - I am new to the STM32CubeIDE - moving from Attolic.I have created a new STM32 project using STM32CubeIDE 1.9.0 for a STM32L151VET6 using New Project.Our board is built to use an internal oscillator. I can try to debug the basically empty new cre...
Hi everyone, I am using the STM32U5G9J-DK2 board and have generated the USB Video Class (UVC) code using CubeMX. However, I am new to both this board and UVC, and I am facing difficulties in understanding how to proceed further. I couldn't find any s...
I use STM32L431 to enter STOP1 mode, the original power consumption is 53uA. Before entering stop mode, I call HAL_ADC_DeInit(&hadc1) to disable ADC, and call MX_ADC1_Init() to re-enable ADC after exiting STOP1 mode. The measured power consumption is...
Moved from https://community.st.com/t5/stm32-mcus/stm32-arduino-stm32duino-tutorial/ta-p/49649 After you have finished the arduino project, how do you then remove everything from the MCU and use it again for normal STM32 projects in CubeMX and so on?
Good morning everyone!I have a question regarding a USB to UART IC. I’ve seen that the FT231XQ is used in ESP32s to program and communicate via UART. Is it possible to do the same with STM32s?
Microcontroller : STM32L476RG, External flash : AT45DB041E (4Mbit, 256 bytes of page, 2048 bytes of block),SPI2 communication protocol, using HAL.I am not able to use the LittleFS library in order to read a file that is written into the flash or any...
I am new to Arm but old to assembly coding (inc Toshiba 32 bit CISC - now extinct).. Just completed RCC startup code for a STM32F344 chip by looking at the 1124 pages (!) of the RM0364 manual and the CUBE LL start up code (!!!). The CUBE code has wai...
Hello, we have Custom PCB Board which Build's around Stm32F4 Series Micro Controller.In which we have Two USB Port, One Connected with External ULPI (High Speed 480mb/s) Another Connected with internal ULPI (full Speed 12mb/s). And we are U...
Hi,I am new to DMA interfacing on the STM32 Nucleo C031C6T6 board. I am trying to send ADC conversion data to UART using DMA. I have tested the code in debugging mode, and after calling the HAL_ADC_Start_DMA() function, the program control seems to g...
I am trying to use STM32H747IGT6 as a USB device. I want to sent data using CDC. Below you can find my configuration and code. The MX_USB_DEVICE_Init() is successful. Although when I call the CDC_Transmit_FS, it never returns USB_OK and I wasn't able...
