Hi,Is it possible to share the PCB File of the Board "X-NUCLEO-NFC03A1" with us.On the Website under this link we could only find the Gerber Files and BOM File of this Board.X-NUCLEO-NFC03A1 - NFC card reader expansion board based on CR95HF/ST25R95 ...
In the schematic for the X-NUCLEO-GNS2A1 it shows the SYS_PSS signal going to J 29J29 shows as being connected to either nothing (PINs 1-2) or "D2D6/PWM" (Pins 2-3)This is incorrect, the actual circuit is:PINS 1-2 connect SYS_PPS to D2 on CN5.3 PINS ...
Hello everyone. I'm new to this platform. I'm working on PCB design and just started learning. Currently, I'm working as an intern at an avionics company. I've been asked to work on a project using a microcontroller and an IMU sensor. Due to the avai...
Hello everyone. I'm new to this platform. I'm working on PCB design and just started learning. Currently, I'm working as an intern at an avionics company. I've been asked to work on a project using a microcontroller and an IMU sensor. Due to the avai...
HiWe are using the STM32U5A9J-DK Development Kit.I want to connect an external device over SPI to the Board using the SPI3 wired to the CN10 Pin see the schematics. As from the datasheet of the development board and also found in the schematics, the ...
Hello everyone,I'm looking into making my own stm32 board to suit my needson the nucleo family of MCU's there's a built in st-link using an stm32f103 similar to those features in bluepill.I'm wondering on how could i replicate that setup where there'...
Hi I am looking for a schematic of the NUCLEO L053R8 board. Where can I find it?
I have this board (revision C-04) with ST-LINK removed (PCB cut off), so the power 3V3 is supplied from CN7. It works fine, but the red power led (LD3) also works. LD3 is, I think, connected to the 5V net, and 5V to 3V3 regulator should not be workin...