Ask questions and find answers on STM32Cube packages, including HAL, LL and middleware, and expansion software.
Hi,I am starting to implement USB PD Sink application and i run into issue.I followed the AN5418.Seems the BSP_PWR_VBUSGetVoltage is Obsolete and i did not find any info how to implement it in alternative way. Found some posts that hint this might be...
Hi!I'm working with STM32CubeIDE and I want to send data via UART using the code below. char *msg = "Hello\n"; HAL_UART_Transmit(&huart6, (uint8_t *) msg, strlen(msg), 100); But I get an error like this:What can I do about this issue?
Hi all, I use UART8 of the STM32F732VE with 921600bps. And I want to use UART rx dma with RTO interrupt in the following sequence. 1. __HAL_UART_ENABLE_IT(&huart8, UART_IT_RTO)//interrupt enable 2. huart8.Instance->RTOR = 0xff00 //set timeout 3. HAL...
Hi All,I am having difficulties getting both HEXSPI PSRAM (XSPI1) and OCTOSPI (XSPI2) running at the same time in a memory mapped mode on STM32H7S78-DK board.There are two examples for this board:XSPI_PSRAM_MemoryMapped that configures XSPI1 in memor...
Hi Team, Currently I am working with STM32U575ZiTx SOC and I am using Tim3 for counting external clock pulses, Can you guide me with the code please. Below is my requirement : 1. What is the maximum frequency of the incoming signal? (To ensure the t...
"I am currently developing a custom bootloader for the STM32F072RBT6 microcontroller. The bootloader is functioning correctly in terms of receiving via UART and writing application code of varying sizes into flash memory . I have verified the correct...
Hello,We have made a devboard with stm32h7s3, running at VDD = 1.8V.We are finding that a number of pins shared with the USBHS/FS peripheral (which we are using as simple GPIO) do not work properly, ie. cannot be used for digital output.This is for s...
Currently, I've used the MPU_Config function to set up memory protection for multiple regions.I want to read back the configuration registers to verify the settings. However, after examining the HAL_MPU_ConfigRegion function in the stm32h7xx_hal_cort...
Hi All,I have previously experiemented with USB HID mouse coding on STM32F0 series and got code working very quickly.However, I am now trying to get the same going using USBX on STM32C0. My application has been built in MX but wouldn't enumerate. I a...
Dear community,i'm trying to use tinysub for WebUSB application.My device is already see as a HID device....In copy, my USB_descriptor.c #include "tusb.h" #include "usb_descriptors.h" #include <string.h> // Identifiants USB #define USB_VID ...
