Ask questions and find answers on STM32Cube packages, including HAL, LL and middleware, and expansion software.
Hello, I wanted to try I2C communication on my Nucleo board since I'm planning to use it in one of my designs. I connected together pins of I2C1 and I2C2, turned on internal pull-ups on both sides for all the pins and wanted to transmit "HELLO" from ...
According to manual below, function should SEND out a SOLICIT message.Function returns NX_SUCCESS (0x00) means SOLICIT message successfully sent. Actually code, after some checks, just set nx_dhcpv6_state variable in DHCPv6 to NX_DHCPV6_STATE_SENDIN...
In AZRTOS - NetXDuo ver 6.4, netx-duo-dhcpv6-client library,if NX_DISABLE_ERROR_CHECKING is not defined (i.e. calling first _nxe_dhcpv6_client_create()),function nx_dhcpv6_client_create() should check for valid input parameters and return errors acco...
Hi, I'm having trouble getting my application to run at a different firmware address. The end goal is to be able to have the application running, receive new firmware over the UART. The new firmware will be saved higher in Flash (0x08100000, LENGTH...
Hi there,I am trying to set up UART3 to receive and transmit using Interrupt.My setup is simple to verify the issue. These are the steps that I did:1. Add Uart3 in .ioc file with the configuration as:2. In main(), before entering while(1) loop, I sta...
Hi,I'm using the CMSIS-DSP library for FFT calculation, using build-time configurable FFT lengths in the range 64 - 1024. The CMSIS-DSP documentation recommends that, when the FFT length is known, using an appropriate initialisation function such as ...
Hello,I have been facing this issue of "No source available for "<signal handler called>() at 0xfffffffe"" on a nucleo-h753zi board. Following are few logs obtained from STMCube Programmer.1. Fault that is eesca;ated to a hard fault (forced)2. Faulty...
HiI need guidance on how to write the logic for interfacing the STM32F407 with the IIS3DWB vibration sensor after installing the X-CUBE-MEMS1 package and selecting SPI2 to generate the code.
Hello,I am using the STM32F413ZH model. In fact, there is no problem in the code I wrote below, everything works correctly, but if I call the HAL_ADC_START function outside the while and do not use the HAL_ADC_STOP command, this time it only makes on...
Hi,when I increase the size of the ThreadX trace buffer above 30k the RTT output is not working anymore (Below 30k RTT works fine). static uint8_t trace_buffer[1024*64] __attribute__((section(".trace"))); My guess is that the RTT viewer can't find th...
