Posted on January 11, 2018 at 10:48I want to use UART with on board.So,is it possible to use st-link as a uart communication.If yes,then how and if not then any other option to communicate with uart by using on board circuit.Thanks & Regards,Kishan ...
Posted on December 26, 2017 at 20:23So I made a custom STM32F446RET6 board and I first used a mini ST_LINK programmer to connect to the MCU. I was able to program it but couldn�t debug it since the mini ST_LINK programmer doesn't have the SWO pin. I...
Posted on December 20, 2017 at 19:06When the DISC1 board is connect to a Windows PC, it is seen as MSC USB drive of 2MB capacity, labeled 'DIS_F429ZI'.I can write files to it and they are readable from Windows.I assume the files are stored in the ST...
Posted on November 20, 2017 at 19:13I am trying to use a Nucleo IHM04A1 motor driver expansion board mounted on a Nucleo STM32F401. The virtual com port shows up in the device manager and I can select it from the ST SPINFamily Evaluation Tool softwa...
Posted on April 16, 2017 at 04:55Hello, I have problem with a custom stm32f437 based board. It was working for few days then suddenly stopped working and can't program it anymore From keil/St-Link setup.Installed the ST-Link utility (V4.0) and updat...
Posted on August 15, 2017 at 22:08Hello, I'm developing some program using STM32F429-DISC1 board and I need to use UART1 there. I'm little confused, because UART1 sort of overlaps STLINK circuits.To be more specific, PA9 and PA10 from STM32F429 go t...
Posted on May 23, 2014 at 00:05Hello all!,For everyone with an STM32F429I-Discovery board trying to upgrade the ST-Link firmware thru the ST-Link Utility version 3.4.0. If you don't see the DFU mode present message on connect and ST-Upgrade refuse...
Posted on October 10, 2017 at 18:26Hi,I am using a stm32f411 with 512Kbyte flash.I want to create a dump hex file of the flash as a backup.What is the Value of 'Size' 0x???? I have to write into the st link utility form to create an exact dump of 5...
Posted on August 26, 2017 at 00:28Hey guys!I currently have a problem with the connection between the debugger ST-Link V2, ARM Atollic 8.0.0 and a custom board with STM32F469. The Atollic and the ST-Link utility believe the Target is halted (and can...
Posted on August 30, 2017 at 09:261 https://electronics.stackexchange.com/questions/221895/stm32f407g-disc1-not-working-if-not-connected-to-pc1I have a Discovery board STM32F407G DISC1.I had programmed a Discovery board before with no issues. The o...