Ask questions and find answers on STM32Cube packages, including HAL, LL and middleware, and expansion software.
Hi, I need to read 8 channels through the ADC in DMA circular mode, to check the channel status readd I put all channel to GND from nucleo board and two channels (ADC_IN2 on PA2 pin and ADC_IN3 on PA3 pin ) doesn't give me the correct data, you can ...
Hi,I'm working on an STM32F303RE project.So far, only the UART and TIM3 are working properly.I successfully configured TIM3 in PWM mode on 3 channels, and everything runs as expected. Project is build only on CMSIS libirary. void clock_config(void) {...
Hey all,I was just reading out the new release of the X-CUBE-Audio-Kit and it says:Configurable latency mode and audio buffer sizes adjustable down to fractions of millisecondsDoes anyone know the lowest latency that can be achieved?I'm looking to po...
With a STM32u5 controller I'm trying to reach stop1 while still receiving incoming uart data and putting the data memory with DMA. I use LPUART1 and GPDMA1 with the receiving side configured to receive a interrupt on bus idle (RTO) and the DMA is use...
Hi, I am having issues with threadX tx_byte_allocate throwing a hard fault exception. This only happens after some time of byte allocate and release. There are still plenty of available bytes according to the pool. But somehow in _tx_byte_pool_searc...
Dear colleagues, hello! Question about LWIP. I have two network interfaces, one on the QCA 7000 chip via SPI, the second on LAN 8742, installed on the debug board. I use the Socket API. The problem is as follows: The server is running on one interfac...
Hello,I'm having trouble establishing a working SPI connection between an STM32U585 and a sensor (LIS3DHH). The transaction looks great on an oscilloscope: Clock, CS, MISO, and MOSI are behaving as expected.This leads me to suspect that the MCU isn't...
Hi, I'm working on the project using STM32H723 with an external flash (winbond 16MB), I already using Azure RTOS Threadx for my project, My PCB has SPI Connection with the flash, all the Levelx examples are with Quad SPI, any Levelx examples with S...
Hi,I am currently working on a build container for my project and I’m using the ARM toolchain (arm-none-eabi-gcc) from ARM Developer sources: https://developer.arm.com/downloads/-/arm-gnu-toolchain-downloads .Do you have an authless link that provid...
I tried to use FLASH_TYPEPROGRAM_FAST in a G0B1 but is not working after a page erase. I suppose it will work with mass erase but not tried. Only works FLASH_TYPEPROGRAM_DOUBLEWORD. I've also tried to make my own function to write only 32bits modifin...
