Ask questions and find answers on STM32Cube packages, including HAL, LL and middleware, and expansion software.
Dear All,It is my first message here, so I would say hello to everyone.I'm trying to send some audio signal through I2S bus on the discovery board using the onboard CS43L22 audio codec. I've configured the codec using I2C and I2S on SPI3 peripheral.I...
Hi. I'm using STM32CubeMX Code Generation for the STM32H745-DISCO (STM32H745XIHx chip). with firmware STM32Cube_FW_H7 V1.5.0.When a timer is set as the timebase source for the M7 core, an assert is triggered in the call to 'HAL_NVIC_SetPriority(...)'...
I am trying to record audio using analog microphone input from 3.5 audio jack in Stm32f769i Discovery board. But i couldn't able record audio from this line input audio jack.
Hi to all,I want to configure DFU to create a USB bootloader for STM32F401RE (I need to understand it on this hardware for future implementation on different MCU). I have some questions.I configure CubeMX as the .ioc file attached.The main settings a...
I am using STM32H7 MCU and Cubemx ide. I am facing an issue with ethernet connectivity with the Nucleo board which has STM32H743 mcu.I have configured Connectivity ETH and set the mode to RMII and enabled LWIP from the middleware. I tried DHCP enable...
We have a situation on our stm32f765 running freeRTOS on one of our production ongoing avionic product. We see that with new lot of production units are hitting usage fault with INVPC status on USFR.Can some advice be provided on figuring out the las...
Hi, Am trying to create the ASC model which is existing in FP-AI-SENSING1 Pack. When I was converting from keras model to TFlite model am getting below error. Am using the same code which is in the pack, am not changing anything. Even the audio file...
I wasted many, many hours because the datasheet and app notes give the wrong boot address. For those of you that need to jump to the bootloader on the H7, use the following:// Bootloader actual start of vector table is here...// No idea why the F&@# ...
Hi, everyoneI have 2 project in one of the project i have used hal library for stm32f1 while in the other project i have use register access i.e all the peripheral like uart, adc are accessed at register level like in stm8 pls suggest is it possibl...
Hello everybodyI want to use speex in my project based on st application note in speex demonstration and it's code ... my hardware is f407 discoveryMy question is : is there any option to implement speex in wideband mode with good quality in f407 boa...
