Ask questions and find answers on STM32Cube packages, including HAL, LL and middleware, and expansion software.
Dear STM32 Community, We believe that the example projects provided for the STM32Cube embedded software are a valuable resource when developing projects. We would like to better understand how developers use these examples in their workflow and e...
Hello, is it possible to boot FSBL and load application from SD card upon powerup, bypassing onboard flash? I didn't see any clear guides on this procedure.Thank you
In testing the LoRaWAN_End_Node_LBM application supplied with STM32CubeWL-1.5.0 release I found that the output power is substantially lower than the same test setup with the LoRaWAN_End_Node application supplied with STM32CubeWL-1.4.0. This testing...
@FBL Can you explain me about buffer descriptor table (BDT)? Is it fixed?I have got behavior that I can't explain.Dumping packets on host I got wrong data. Length is ok, but data is wrong.In BDT I wrote correct address and length. Data wrote...
I am coding from the scratch to learn how STM32 works with MIPI-DSI LCD, because I am going to use customized MIPI-DSI LCD. I refer to the official code, but some incorrect content as below:official default code: in main.c , static void MX_LTDC_Init(...
I am trying to capture data from the LINE_IN (blue jack on board), but I am not receiving the correct input. I evaluated my output at the oscilloscope and noticed that I am not receiving the sinusoid I am injecting; the frequency is correct, but the ...
Dear community members,STM32H7S78-DK: USBX standalone (CDC ACM + PIMA) works in HS now but PIMA / MTP is not supported in standalone mode in USBXCurrently, it is not possible to use the PIMA/MTP class in USBX in standalone mode (without an RTOS). The...
Hello, I configured TIM5 to generate a signal out to a pin using STM32CubeMX2 for a Nucleo-C562RE board. I enabled the EXTI interrupt for the pin in the timer configuration to get EXTI6 interrupts on the falling edge. I also enabled the use of regi...
Hey there,I'm currently trying to port a project that I was using successfully on the STM32U5A5, to the STM32N657.The project utilises the PDM2PCM library to convert a PDM audio stream received from a MEMS microphone via the SAI interface of the MCU ...
Hi ST Community, I'm facing a critical and reproducible hardware JPEG encoding issue on the STM32N6. The JPEG encoder only works correctly when the image width is exactly 800 pixels. Any other width I've tested — including 480, 960, and 960x480 — cau...
I had some issues configuring H573 with CubeMX.When I configure TIM2 or TIM3 according to the instructions of RMII_PTP_Synchro in CubeMX I cannot enable the RMII PTP functionality.And when looking at RM0481 it seems that the description of the rela...
