Resolved! NUCLEO-C5A3ZG STM32C5 QSPI Display Bring up Project
This project tests the STM32C5's XSPI capability to drive QSPI display using the NUCLEO-C5A3ZG M.2/SerialMem connector. GitHub - stm32-hotspot/STM32C5-M2-Serial-Mem-QSPI-Display · GitHub
STM32 MCUs Boards and hardware tools
Ask questions and find answers on STM32 hardware set-ups, including schematic-related challenges, debugging probes, power configurations, and more.
Forum Posts
Change OSC_IN pin with OSC32_IN ?
I am using STM32F030C8T6TR. An external 8 mhz oscillator was connected to the OSC_32_IN-OUT input by mistake, not to the OSC_IN-OUT pins on the board I have. Hardware cannot be changed. Can I reconfigure the pin with software or How can I use it? I a...
I CAN NOT DEBUG STM32F407 ?
There is St-link embedded for the stm32f407 card, but I don't know how to use it, is st link v2 still required to debug it? Please help I'm going crazy.
Buy STM32F103CBT6 pre-programmed with ST-Link firmware?
STM32F103CBT6 is the same MPU used on the Nucleo demo boards as an ST-Link implementation.Is it possible to get these processors pre-programmed with ST-Link firmware?Under what conditions, if any?
Failure to convert ST-LINK to J-LINK
STM offers a utility to convert an ST-LINK debugger to J-LINK debugger.USB drivers are current.But when "stlinkreflash.exe" is run [in admin mode], it says "cannot find an ST-LINK, multiple ST-LINKs are plugged in, or ST-LINK in use".None of that is ...
STM32H7B3I EVAL Jumpering for USB Host
The STM provided USB host project has the following readme text:- STM32H7B3I-EVAL Set-up - Plug the USB key into the STM32H7B3I-EVAL board through 'USB micro A-Male to A-Female' cable to the connector: - CN8 : to use USB High speed (HS), Make sure...
Resolved! Dimension of STM32F746IEK6
what's the dimension of STM32F746IEK6. Especially for thickness, is there any tolerance ?
Resolved! Debugging with ST LINK V3 aborts when accessing external SRAM via FMC.
Hello all, I have a very strange problem with Debugging. I am using a STM32H723xx microcontroller for my project. I have some debuggers like ULINK ME, ULINK2, JLINK, ST-LINKV2 and V3. All debuggers show the same issue.I access the external SRAM via F...
