Hello STM32 Community,I am currently working on a customized controller board with the same architecture as the EVSPIN32G4-dual, using the STSPIN32G4 and STDrive101, to control two BLDC motors. However, I have encountered a few issues and would appre...
Hello, I am trying to use STM32 Motor Control Workbench(which I downloaded from the material of Motor control part 5 package) to control a BLDC motor with FOC. The motor I have is a custom one, the control board and power board are going to be custom...
Hi all, I have been trying to control my BLDC motor with an condition where if the surrounding temperature increases a threshold temperature the bldc motor should turn fast else slow. I am using lm35 as temperature sensor, i was able to interface thi...
Hello! I'm trying to configure the following setup to run the motor profiler in order to characterize a set of small/low-power BLDC motors. Configuration:I'm using MCWB 6.21Control board: Nucleo F401RE in the following configuration:JP5 at U5V,JP1 OF...
Hello,i am trying to run the Evalkit-Robot-1 example project. unfortunately i get the error "configuration files cannot be found in 'MCSDK_v5.4.4/MotorControl'. This version is no longer available for download. Is there an updated version of the exam...
Hey everyone!I was just exploring different features of the ST MCSDK and encountered the on-the-fly startup option dedicated to fan application.Whenever I check this option, after the startup procedure, the motor accelerates to its nominal speed and ...
When STM32G431 is used for motor control, the left alignment cannot be selected after oversampling is enabled, but the program will report an error when it is changed to right alignment. May I ask why?
MCWB Version: 6.2.1CubeMX Version: 6.10.0Issue: I generate a default project for the B-G431-ESC1. Only settings I change is to enable the FreeRTOS with TIM6 as the tick timer. Firmware Package Version is V1.5.1 (Recommended).Via CubeMX I add a GPIO o...
Dear STM32 Community,I am reaching out to you regarding a specific inquiry about the development of a prototype that involves controlling BLDC motors using an EVSPIN32G4 demo board. Our aim is to set up a test stand where the motor speed control is c...
Hello everyone,I am running into a problem with the STSPIN3202 evaluationboard. I cant get my BLDC motor A2212 930KV 15T with sinusoidel BEMF to spin.I have tried 6 step sensorless and FOC sensorless. In case of 6 step the motor keeps buzzing station...
