Ask questions and find answers on STM32Cube packages, including HAL, LL and middleware, and expansion software.
I am trying to interface DS18B20 (Temperature Sensor) with STM32L072 using OneWire communication. But not able to generate proper delay.I have reached some of the solutions but did't worked.https://community.st.com/s/question/0D53W000003LJZsSAO/micro...
void DMA_DoubleBufferModeConfig(DMA_Stream_TypeDef* DMAy_Streamx, uint32_t Memory1BaseAddr, uint32_t DMA_CurrentMemory)What is your role?
I am working on a project that requires 3 channels of ADC1 and FreeRTOS.I am using STM32F446RCT6. I start ADC conversion at the start of the code HAL_ADC_Start_IT(&hadc1);Here is my implementation for ADC callback.whereas array to hold data is descri...
I'm using STM32H745. Both cores run FreeRTOS 10.2.1. Timebase for CM4 is TIM6, and CM7 is TIM7. For some reason, on CM4, from the time osKernelStart() is called in main() until StartDefaultTask starts to run is about 5 seconds ( i turn an LED on just...
Hello guys,I have a small question I have st link v2.1 which comes with the Nucleo board, so I need to program another custom board using this st link, but I have to do using UART (Rx, Tx) pins which is nearby the SWD connector, please if anyone has ...
Hi,I have STM32F030 which is connected to STM32L082 with UART (Rx/Tx), RESET and BOOT0 line. When needed STM32F030 is able to restart STM32L082, run ROM Bootloader, erase and program flash.But when I have clean STM32L082, empty flash on it on product...
So I notice when I configure my STM32F769 Discovery board as USB Host, the generated middleware already have built in logging USBH_UsrLog() which is handy.But looking at it definition on the macro, basically it wrap standard printf() like following:#...
I have seen a similar thread for the ST25R3916-DISCO (making appropiate changes in stm32l4xx_hal_msp.c ), however in this board the USB pins are not connected to the same pins and I am not capable of correctly reconnect the solution to PA11, PA12.UAR...
@Ons KOOLI. Hi, i want to use stm32f103 or stm32f1 family microcontroller for mass storage in usb for data logging.any reference and example are pretty useful as i am new to usb logging with stm32.
HiI am trying to implement a fault filter for the HRTIM on a stm32G474.I am using the LL libraries and the Reference manual.I find the table 234 in the reference manual completely unreadable and confusing. Could someone please explain how it is suppo...
