Ask questions on STM32CubeProgrammer and find answers on device detection, connection failure, programming issues, and more.
We are pleased to announce that STM32CubeProgrammer 2.20 is available What is new in 2.20: • Support for the STM32MP21x microprocessors: – External memory programming – OTP programming – PKCS#11 – ST power management IC• ...
Debian version: debian@sys:~/STM32Prog$ cat /etc/os-release PRETTY_NAME="Debian GNU/Linux 11 (bullseye)" NAME="Debian GNU/Linux" VERSION_ID="11" VERSION="11 (bullseye)" VERSION_CODENAME=bullseye ID=debianVersion of STM32CubeProgrammer - v.2....
Without starting the STM32 Cube Programmer (GUI) I get following error message:-------------------------------------------------------------------STM32CubeProgrammer v2.17.0-------------------------------------------------------------------ST-LINK SN...
I'm trying to interact with the external flash on the STM32H573I-DK, and having some issues. I'm using the `MX25LM51245G_STM32H573I-DK-RevB.stldr` external loader.Using the J-Link, I can read the flash and erase sectors, but the program immediately c...
Hi,I am working on STM32G491KCU6 board.We are connecting STM to a linux based SoC via SPI. What we required is, we need to flash STM from SoC. We found stmflash binary which supports only through i2c and UART. Is there any tool that support flashing ...
Hello,In one of my boards I was planing to use CANBUS bootloader and STLink V3 with external canbus PHY to program MCU.I was unable to program it, I can see STlink V3 does try to do some TX on CANBUS pin, but where is no packet available that could b...
Hi,i have an issue, where i implemented using DMA. The DMA works seemingly without issues, but when debugging and using the start/pause buttons, the hard fault happens.Would the be a smart way to *simulate* a pause/start of a debug session??EDIT:I fo...
Ive been trying to use the FDCAN systembootloader from a stm32H757XI, in the past i managed to use the CAN systembootloader from a stm32f405RE succcesfully. But im getting> nothing , i tried with 125 and 250Kbauds, CAN connceted to PH14 and PH13 Is...
Is FDCAN Systembootloader described in AN5405supported by cubeProgrammer or the CLI tools?Because i only see the CAN (classic) option
Hi there,I have an ST-Link V2 which i want to use for programming a .bin file to an stm32G0 MCU. Afterwards i want to set the RTC register to the time beeing. It already works "manually" but i wanted to write a script to automate the process.I alread...
Hi, I'm making a board for UART and I2C communication.Please refer to the schematic below; I put 5V External power supply at VBUS,and connects SWDIO, SWCLK, NRST, 3V3, GND to the STLINK V3 Minie. However it shows "No STM32 target found" message on S...
