After Install launching returns CubeProgrammer_API is missing. Please try reinstalling or check you java architecture. Ive seen some other forum posts with this issue and tried to fix the java version to no avail.Current java version is java-1.8.0-op...
Hello,i just installed the most recent version of Cube Programmer but when i click the Open File tab and select a folder the program crashes immediately. I'm running it in Windows 11 64-bit on an Acer laptop, i selected the correct 64-bit version for...
Hi, tried downloading STM32CubeProgrammer software for all STM32 but as soon as I accept terms, the download doesn't start. I have tried as a guest with my email and with my account. I don't have any add blockers and have tried with my antivirus acti...
If driver porting is successful, reading and writing eMMC from STM32CubeProgrammer should be feasible.I have tested that the read, write eMMC functions are ok and implemented in read, write, MassErase and SectorErase functions of Loader , but from th...
Hey everyone,I was writing a 'How-To' for flashing an STM32F04 while I stumbled upon this phenomeon.After program&verify I read back the device memory and compared it to the file I downloaded.I then get the message 'Warning: difference found at 0x800...
Hi,I am conducting tests with the HSM and SFI. I have tried the use case of attempting to install an SFI with an HSM that uses other keys. Obviously, I couldn't do it, but now I cannot connect the microcontroller in "normal" mode. If I connect it in ...
Hi Everybody, I try to flash my firmware into NUCLEO-STM32F410CBT6, first, I didn't remove CN2 Jumpers for nucleo ST-link V2. and then, select nucelo board in cube32Programmer after that, click connect button, it works well. but, I want to flash pro...
During the installation of the STM32CubeProgrammer creates some registry keys under:HKLM\SOFTWARE\Microsoft\Windows\CurrentVersion\Uninstall\STM32CubeProgrammer 2.16.0\One of them is "UninstallString" with the value:cmd /c start /min cmd /c "C:\Progr...
STMicroelectronics ST-LINK GDB server. Version 7.7.0Copyright (c) 2024, STMicroelectronics. All rights reserved. Starting server with the following options:Persistent Mode : DisabledLogging Level : 1Listen Port Number : 61234Status Refresh Delay : 1...
While installing the program for my windows 10 it hangs at step 8 which is shortcuts set ups. So I have been reaserching the internet and forums for a while still didn't manage to find a solution