Instead of completing development of STM32CUBE Programmer - every one now need to follow some manual steps with unknown versions of firmware with many undefined startup addresses and even when all steps are completed with success - development board ...
I managed to get the setup program to complete by running directly from the command line.The STM32CubeProgrammer app fails to run, giving the follow error trace:CubeProgrammer version: 2.15.0Path CubeProgrammer version: : /Applications/STMicroelectro...
HelloFor my project I use a stm32g491rct6 with 256k flash. STM32CubeProgrammer 2.16.0 show the block contiguos 0-255 from 8000000 to 807ffff while STM32CubeProgrammer 2.17.0 show blocks 0-63 from 8000000 to 801ffff and 65280-65343 from 8040000 to 805...
I was updating CubeProg on MacOS 14.5 and had a few issues, but first IT WORKED. It let me know that administrative privilege is required (it isn't), but it plowed ahead and worked anyway.Here are the things that I ran into:It does this on 2.16 as we...
Hi,Updated from 2.15 today. Having DFU download problem seen attached.Board is recognised but upper right still stated as "Not connected" and download fails.Downgraded to V2.15 and same board connects and downloads OK. OS: W10 64bitBoard: STM32F767NI...
Our customer attempted to update the firmware on their device which uses an STM32L433CC. Programming failed to erase and download the firmware on the device. STM32CubeProgrammer 1.4.0 succeeded in programming the device.Customer is using a Windows 11...
STM32CubeProgrammer version 2.16.0Target STM32G0B0RET6, device ID 0x467, Rev Z, 512KB flash, bootloader 0xD0When loading a large bin file (425kB), the programmer tries to erase 65364 sectors! There's only 256 sectors in target, and the image only nee...
Hi, tried downloading STM32CubeProgrammer software for all STM32 but as soon as I accept terms, the download doesn't start. I have tried as a guest with my email and with my account. I don't have any add blockers and have tried with my antivirus acti...
STM32_Programmer_CLI fails to list UARTs unless an STLinkV2 is also connected to a USB port (not even to any target). If an STLink is connected, the UARTs are then listed! Disconnect the STLinkV2 and the UARTs fail to list. So the issue appears to...
Hello,i just installed the most recent version of Cube Programmer but when i click the Open File tab and select a folder the program crashes immediately. I'm running it in Windows 11 64-bit on an Acer laptop, i selected the correct 64-bit version for...