STM32CubeProgrammer v2.18.0 release information New features:• Added the support for the STM32U3 series– Internal memory programming– Option byte/OTP programming– Core register programming– Regression with password (close/open)– SFI support– Key wrap...
Hello everybody,I come back with a similar issue I've wrote in Issue in buffer to write before programming external flash but with a different memory, now is a NOR flash S29GL128S.I can read and write any address of external memory properly. Also I c...
Hi, I am working with Open Bootloader and referring to a video tutorial for the same. While I am referring to this video I am not able to set the user firmware address from 0x08000000 to 0x08008000 as mentioned in this video following the same steps ...
It seem that ST-LINK_gdbserver does not implement load to run.(gdb) tar ext :61234 Remote debugging using :61234 0x0800004e in ?? () (gdb) info mem Using memory regions provided by the target. Num Enb Low Addr High Addr Attrs 0 y 0x00000000 0...
Hello,I have developed a external Loader for my custom projekt. It uses a W25Q128 QSPI conected to bank 2 and alternative Pin of CLK. (Worse!, but it is so...) So i Have no exactly example for it. Also it is a Dual Core, and no example i find have sp...
Almost all development boards produced by Chinese vendors use CH340 as the uart converter chip, I would like stm32cubeprogrammer to be able to control the RTS and DTR of this chip.If the feature works fine for the FT232RL, I don't know why it won't w...
HI: I want to write the board SN, REV, TIME to STM32C031F6 OTP area 0x1FFF7000~0x1FFF705F, which is almost 96bytes to write, from the stm32cubeprogrammer manual -W64 command can to write, but is needs to be repeated 6 times, right?Also from the manua...
I cannot uninstall STM32CubeProgrammer v2.16 (64-bit) from my Windows 11 64-bit system.If I try to uninstall it from the Windows Apps->Installed Apps list, a terminal window briefly flashes on the screen and then nothing else happens. If I go to C:\P...
I am trying to program a chip using an STLINK V2. I am using only SWDIO, SWCLK, and ground, and I am powering the chip with 3.3 V. When I try to connect using STM32CubeProgrammer, it does not connect. Am I missing something?
Hi everyone,I've a strange problem when I write to an external flash memory (S29GL512T) throught a STM32F767 MCU and a custom external loader loaded in the STM32CubeProgrammer.After debugging the external loader several times, I've found that the con...
Hello,The main purpose of the question is to avoid giving source code and give binary file instead.For example, I generate a compiled binary file from a nucleo project (STM32H743ZI2) for the M7 core.Then I want to create a new dual core project (STM3...
