I'm new to stm32 programming, but have experience with other complex low level drivers. I'm looking for ideas because I'm confused by this issue.I hired a contractor to write code to view a few sensors, monitor a few rotary encoders, and use a 320x2...
Good day. Faced such a problem. I wrote a loader for a non standard board, using stm32f476vgt MK, N25Q128A memory in extended SPI mode. All functions are tested in debugger mode. The data is written correctly, the memory is erased correctly, but veri...
Could someone to give a link to an "Linker Code" about which is mentioned in paragraph 12 in this tutorial https://community.st.com/s/article/how-to-add-your-spi-flash-into-the-stm32cubeprogrammer-external-loader-part1
Is External loader programming possible using SPI through STM32CubeIDE(It should program internal and external memory at the same time)?I am able to generate .stldr and program the external serial flash(Connected via SPI) using this file(.stldr) in S...
Is there a way to program spi flash using st-link? The spi flash which i am using is AT25SF321B.
According to UM2237, the Connect command in the CLI (command line interface) supports SPI, but what is the device used to connect the Nucleo board to the PC? How does the device look like from the PC side (device manager)?---> start (added to questio...
Hi,I'm trying to migrate an old firmware from a STM32F303 to a STM32G474.The MCU is related to an external Flash W25Q16JV.The old configuration uses the SPI bus to communicate with the external flash.So I changed the program in order to adapt the new...
Hi, I am trying to program stm32 through SPI. I am trying to use C232HM USB 2.0 HI-SPEED TO MPSSE CABLE (C232HM-DDHSL-0 - FTDI (ftdichip.com)). I have connected the microcontroller through SPI1. The SPI connections is as follows with the FTDI cable:S...
Hello there,I am working on a project. In the project I want to implement, an external ADC module will collect the data and transfer it to the STM32F103C8. My STM32F103C8 microprocessor will transfer these data to my wireless module. Here I am having...
Does anyone have a decent recipe for creating the ST-Link compatible driver for an SPI NOR device? Using the examples in STM32 ST-Link utility I have been able to create and debug the needed routines to intialize, erase, write, and read my flash in...