STM32CubeProgrammer (MCUs)

cancel
Showing results for 
Search instead for 
Did you mean: 

Forum Posts

Resolved! Unable to run code STM32F411RET6

Hi,I'm unable to run code in my STM32F411RET6 when i'm running code, the debugger print :"Open On-Chip Debugger 0.11.0+dev-00449-g53fa0f7 (2022-06-09-09:40) Licensed under GNU GPL v2Info : Listening on port 6666 for tcl connectionsInfo : Listening on...

LBien.1 by Associate II
  • 996 Views
  • 5 replies
  • 0 kudos

Resolved! Does Registers work in STM32Cube Programmer?

I am trying to use Registers in STM32CubeProgrammer to change the setting of GPIOB, but whenever I change a value. it just gets changes back to the value it had before! Is this because Registers is still in BETA or am I doing something wrong?

KMoel.1 by Associate II
  • 664 Views
  • 7 replies
  • 0 kudos

I have been using the STMCubeIDE to program my STM32_F411RE with some basic GPIO exercises and a breadboard. I encountered a problem when trying to upload the .bin file after successful compile. I receive the following error: "There is not enough space on

NODE_F411RE. You need an additional 128 KB to copy these files. NODE_F411RE Space free: 8 .00 KB. Total Size: 32.0KB.Can anyone please advise how I can overcome this error message.

MRowl.1 by Associate
  • 210 Views
  • 1 replies
  • 0 kudos