About Sungjae Kim

Sungjae Kim · 2025-01-16

Hello, I'm having an issue with the STM32CubeIDE configuration. Due to company policy, my development PC does not have internet access, so I need to set up STM32CubeIDE offline.So, even though I installed the relevant STM32Cube for G0 series, I’m get...

Sungjae Kim · 2025-01-15

Hi, I'm making a board for UART and I2C communication.Please refer to the schematic below; I put 5V External power supply at VBUS,and connects SWDIO, SWCLK, NRST, 3V3, GND to the STLINK V3 Minie. However it shows "No STM32 target found" message on S...

Sungjae Kim · 2020-10-04

Hello,I have questions about handling multiple UART ports.Connections are;PC <--USB VCP--> STM32(1) <--UART1--> STM32(2) <--UART2--> Target deviceTwo STM32 are both L412K series,And I wanna make a application which forwards data to the target device...

Sungjae Kim · 2025-01-17

Hello @Imen.D ,I followed the instructions from that link, but there wasn’t much progress.Here are the results I found after further investigation:If I only download and install version 1.X.0 (without applying any patches), then create a new project ...

Sungjae Kim · 2025-01-16

Hi @Peter BENSCH ,Thank you for kind reply. I will apply. :)

Sungjae Kim · 2025-01-15

STTwo-32, Thank you for prompt reply and catching my mistake.I have twisted SWCLK and SWDIO, now it recognized successfully.Thank you and have a nice day :)

Sungjae Kim · 2020-10-04

Thank you for reply. It was typo.At the program, I applied "HAL_UART_Transmit(&huart2, &data, 1, 10);" at there and it is not working.

User statistics

User Activity

Missing dependencies problem (STM32CUBEIDE offline setup)

No STM32 target found - STM32G030K6T6

How can i handle two UART ports in one STM32?

Re: Missing dependencies problem (STM32CUBEIDE offline setup)

Re: No STM32 target found - STM32G030K6T6

Re: No STM32 target found - STM32G030K6T6

Re: How can i handle two UART ports in one STM32?