STM32CubeProgrammer (MCUs)

Resolved! How to use STM32CubeProgrammer over CAN Bus?

Hi, are there any information's or app-notes available how to use this programmer over CAN bus. I cant find any information which hardware is supported or how make the can hardware on my laptop visible to the programmer. Thanks for your support!

STM32CubeProgrammer don't support CAN

In the introduce page of STM32CubeProgrammer, it descrips that this software support CAN bootloader interface, but I just find the ST-link Uart and USB. How can I configure it to CAN?

I Need to Flash the stm32L431 via CAN bus. I see the STM32CubeProg says it supports CAN. So do I understand correctly that I could simply use a USB-CAN device like those listed below to Flash the board? THx

https://www.usbgear.com/usb-to-can-bus.htmlhttps://www.kanda.com/products/Lawicel/CANUS

Program STM32 through bus CAN

Hello,Is it possible to program STM32* through bus CAN with STM32CubeProgrammer and STLINK-V3SET ?If yes :can we program only one STM32* even if many other STM32* are connected to the bus ?do we need to flash a bootloader or the embedded bootloader i...

STM32H753 - executable code update using CAN, STM32 bootloader and CubeProgrammer

I'd like to have a capability to update an executable code of the STM32H753 using CAN interface, internal booltloader of STM32 device and Cube Programmer. CubeProgrammer documentation (UM2237 Rev 9, pages 19, 47) shows examples with STLINK hardware ...