Haven't found anyone talking about the new API here. I'm trying to code a program that flashes a STM32F334, reads processor's UID and post it to a proprietary database. STM32CubeIDE and CubeProgrammer works fine. I also managed to run C++ API and ide...
I currently program a STM32F303 with the app STMFlashLoader Demo, using a USB-RS232 device. I want to replace that app with CubeProgrammer, but the app is sending an error. I already checked my FW, but it is OK.So, I want to know if you can help me t...
Hi,I'm trying to migrate an old firmware from a STM32F303 to a STM32G474.The MCU is related to an external Flash W25Q16JV.The old configuration uses the SPI bus to communicate with the external flash.So I changed the program in order to adapt the new...
I have a Mikroe Fusion for STM32 V8, I'm using the external DBG selection using an STLINK V3 plugged into the debug port. I can get Cube Programmer to load code onto my F302VC. When I load up STMicroelectronics ST-LINK GDB server. Version 6.0.0, I ...
Hello, I have an issue debug issue in my custom board. The debug session works for a while and then stop to working and suddenly after many tries it works again. When the debug session doesn't work, I get:STMicroelectronics ST-LINK GDB server. Versio...
I designed a usb to UART plug in board on which I like to program my board through STM32F302CC's UART1. If I push the connect button on STm32 Cubeprogrammer IDE(ver 2.1.0) I get the next messages08:20:49 : Serial Port COM3 is successfully opened.08:...
I am trying to flash a STM32F303CCT6, and any time I try to set the Option Bytes to Level 1 protection it locks the board and breaks the connection. The only thing that is able to both see, and wipe the board is an android app.The board has WinUSB on...
Hi there,First time to this community, glad to see you!I have an weird programming issue when using STM32CubeProgrammer.I use NUCLEO-F302R8, and try to download a blink.elf to the MCU.I can have successful download, and the LED is blinking. However, ...