STM32CubeProgrammer (MCUs)

Resolved! OH boy... I bricked my nucleo Error: Expected value for Option Byte "RDP": 0xAA, found: 0xFF

I was happily debugging some code in my NUCLEO-F207ZG, the whole morning the debug sessions (stm32cubeIDE) have been quite glitchy.Until the mcu somehow got briked and i cannot revive it.I suspect noise in the SW lines comming from some external LEDs...

Did I brick my STM32F2?

Hi all -I'm modifying some legacy code written for a WICED device that contains an STM32F2xx. The original programmer had a passage that reduces down to:#define OB_RDP_Level_0 ((uint8_t)0xAA) #define OB_RDP_Level_1 ((uint8_t)0x55) FLASH_OB_Unlo...

Resolved! I made an .stdlr file (in "Release" mode) for ext-loader on STM32F23, copied the file to "prog files....STM32CubeProgrammer\bin\ExternalLoader" but the file doesn't appear in the list of external loaders in cube programmer OR STLink utility?

Resolved! STM32CubeProgrammer cannot connect to NUCLEO-F207ZG board in bootloader mode via UART interface

I have a NUCLEO-F207ZG board and STM32CubeProgrammer v2.7.0. I would like to use the embedded bootloader located in system memory. So, first I activate bootloader mode pulling-up pin 138 (boot0) of the MCU. Then, in order to verify this first operati...

Resolved! I can not change RDP

Hello!I am using a board equipped with STM32F205 VCT7.https://www.hibot.co.jp/ecommerce/prod-detail/16During "Connect" with STM32CubeProgrammer, I accidentally dropped the main power of the board.Since then, such a screen came out when "Connect" was ...