FreeRTOS is currently active. However, the problem occurs before FreeRTOS initialization (before calling osKernelInitialize ()).The board used is a board written by hand rather than a NUCLEO board. When I activate my Peripheral devices other than US...
Hi,I am currently trying to develop the Audio device on STM32F0 to stream audio data from USB to IS2 signal, although It worked without any issues on STM32F4 discovery board, when I am trying to apply same logic for Nucleo32 It does not seem to work ...
Hi.I need to record audio with the line-in jack on the STM32F746G board. I looking for an example that deals with Jack input. Is this possible at all ? Could anyone help me to get line-in working?Thanks in advanceKind Regards
For now, all the information I got about this library is it only supports to F4. So, will it work with F7 ? Thanks.
STM32G071RB USBPD Source:First time, plugin usb-c cable, STM32G071RB send some source cable, the SRC power negotiation finishdisconnect and plugin cable again, the PE task not weak-up, no source cap packet send in type C bus. the source code go to so...
How to Upload some audio file .WAV . to STM32f030C8t6 controller based on memory capacity. Which is the right tool use to upload WAV file into flash memory and how to send it through UART commands.My Actual Application is Upload WAV file to MCU and ...
I want to play audio in stm32f072... I have read um0891 user manual and AN3126 application note...But I didn't get any resource to develop firmware...Your help will really matters....
The usb type c pd example code does not seem to work although it compiles properly using SW4STM32. I tried the provided binary file (PNUCLEO-USB001-DEMO1.bin) and it works just fine. I am using nucleo-f072rb and MB1257 expansion board.PNUCLEO_USB001...
