Hey, I am using a STM32F7676vit6 Controller an try to set up a SAI connection to my audio CODEC now my problem is that the CODEC has two Serial outputs and one serial input. So i configured:SAI1A to be the transmitting master SAI1B is a synchronous S...
Device: STM32F411RE NUCLEOHello, I am having some issues with STM USBD AUDIO library. For some reason I cannot get it to stream audio data to a host device in a proper way.The device is successfully recognized as 2 channel 16 bit microphone by my PC....
Hi all,I'm trying to get to know the STM32 world, and I have a STM32F746G-DISCOVERY board here. I've successfully tested a couple of TouchGFX things, and it seems quite neat.Now I want to test the possibility to output audio signals on the TRS output...
The specific message is LNK1107: invalid or corrupt file cannot read at 0x3F8
I am performing audio acquisition from 4 MP34DT01-M microphones using SAI interface and pdm2pcm library on STM32H743.My first question is about the types of variables used in the PDM and PCM buffers. I am storing data from 4 microphones in 32-bit slo...
Hi,I am using STM32H743 nucleo board. I am looking to configure the USB interface as Audio Class 2.0 device. Is there any middleware available to achieve this?Does STM has any plan to support Audio Class 2.0 middleware? Current middleware only suppor...
Hello,I was just porting a F767 design to an H723-Nucleo, and found out that this H7 Nucleo is using its ST-Link's HSI as a clock source to the H723 at 8 MHz. With the usual terrible HSI quality, which showed itself in low quality SPDIF TX and PTP sy...
Hi,i tried the SAI_AudioPlayback example for the h745 discovery board. I'm using Keil and with the keil 5 armcc compiler everything works fine.Now i switched to armclang 6 and replaced the "libPDMFilter_cm7_keil_wc16.lib" with "libPDMFilter_cm7_gcc_w...
Alright, so I've been struggling quite a bit for the past week trying to get the X-CUBE-USB-AUDIO project working in STM32CUBEIDE on a STM32H745 MCU and looks like I have more or less everything up and running pretty good, at least in 16 bit mode. Pr...
I've worked out how to disable in the MEMs microphone I just want to use the blue 3.5mm input to receive/record the incoming audio. Thanks.