Ask questions and find answers on connectivity ICs, focusing on protocols and I2C challenges on STM32 Nucleo boards and BlueNRG products.
Posted on December 06, 2016 at 15:28Hi,I'm using the Bluenrg-ms chipset with firmware version 7.1.e (0x715). Everything works fine, except from the authorization settings. Each device can connect to the BLE without any request for permissions (PIN)....
Posted on May 30, 2016 at 07:10I have our BlueNRG device set up to use a fixed pin for pairing. I am able to successfully pair with Apple iOS decvices and windows phone when I enter the correct PIN when prompted by the device. However when connectin...
Posted on November 24, 2016 at 11:26Hello, I am using SPWF01.11 FW3.5 as webserver as described in a previous post. This webserver is made of 1 HTML Frameset (main.html) + 3 HTML frames (m.html / sm.html / data.html) to override the 4ko limitation. ...
Posted on November 23, 2016 at 15:58Hi, how can I configure/deactivate the Nagle-Algorithm in SPWF01S? Thanks! MBU
Posted on November 21, 2016 at 20:59Hello everyone!I'm working with ST SPBLE-RF using the C code driver provided for BlueNRG-MS. I ported it for an ST8L151G6 microcontroller; the SPI communication works, the device answers correctly (0x02 and the R/...
Posted on November 18, 2016 at 23:27Hi, i have a problem using SensorDemo_New of BlueNRG DK 2.0.2COPY_ENV_SENS_SERVICE_UUID(uuid); ret = aci_gatt_add_serv(UUID_TYPE_128, uuid, PRIMARY_SERVICE, 10, &envSensServHandle);i get ERR_UNSPECIFIED_ERRORif c...
Posted on November 15, 2016 at 08:58Hi..I can easily connect the module to any APs and it works fine. But, I can not connect it to the iPhone hotpots.. does hotshots needs additional configuration.?
Posted on November 18, 2016 at 12:18I have been using the your WiFi module, The module desciption is below; # nv_manuf = ST # nv_model = SPWF01SA1 # nv_serial = 4313D02202 # nv_wifi_macaddr = 00:80:E1:FF:BA:10 +WIND:1:Poweron (141106-0950875-SPW...
Posted on November 15, 2016 at 17:10Hi,I'm trying to send messages to the host processor (the one communicating with the SPWF01SA module).As far as I know there are two methods:* /output.cgi?text=message* SOCKDBoth output.cgi and the socket server s...
Posted on October 21, 2016 at 14:55Hi, I'm trying for lowest bandwidth settings for higher sensitivity. But packets wouldn't reach. Is there any problem with my settings? #define CHANNEL_SPACE 20e3 #define CHANNEL_NUMBER ...
