Hi I'm trying to enable OTA Service on my device with the BlueNRG2 Chip. I use the Lower Application Scheme. Therefore I flash the BLE_OTA_ResetManager at the flash beginn at 0x10040000. (I did a mass erase before that). I didn't modify the OTA Reset...
I have a simple project I am trying to implement using BLUENRG2-M2SA. It will connect with a user over BT and download a timer length. Then it will run the timer and blink lights when the timer counts to zero. The user then acknowledges the lights...
Posted on December 07, 2015 at 19:00Hi, I use Spirit1 both with 433Mhz and 868Mhz on the same custom-designed board with stm32l1. The radio parameters are set according to the individual transceiver and the software configuration is done seperately ...