STM32CubeProgrammer v2.18.0 release information New features:• Added the support for the STM32U3 series– Internal memory programming– Option byte/OTP programming– Core register programming– Regression with password (close/open)– SFI support– Key wrap...
I am reading a large external memory and it takes several minutes (slow bit banging SPI). To dump it to a file I have to read the memory twice because when I select "Save As" CubeProgrammer reads the default memory size (0x400) (not the 0x800000 I en...
Gaggiuino projesine ait "SetupSTM32CubeProgrammer_win64" programı Hp Victus Windows 11pro bilgisayarıma yüklenemiyor. Son adımda kalır (adım 8/9).EN: The programme "SetupSTM32CubeProgrammer_win64" of the Gaggiuino project cannot be installed on my Hp...
STM32CubeProgrammer v2.15.0 release informationNew features:• Added the NOR flash memory and OTP fuse programming via USB and UART using OpenBootloader for the STM32MP13xx microprocessors• Added the support for the PMIC programming via UART for the S...
After installing the programmer to the system and connecting it to STLINK, I encountered this NOT FOUND error. I don't know where the problem is. Also, my programmer is STLINK_V2.My second question is, when I try to install the STLINK UNITY software,...
HI, We have designed a test fixture for a 6 panel PCB in which we use 6 individual STM programmers (STLINK-V3MINIE) and we sometimes see a problem where windows no longer recognizes one of the programmers and we can't get it back (complete system re...
I am trying to erase my STM32U575 which is on a Nucleo board (U575ZI-Q) and it connected to the computer via ST-Link V3. I can erase the chip fine using the GUI STM32CubeProgrammer, but the command line method does nothing. This is the output I get w...
Hello, I have a problem when i try to load a bin file using External flash. I created my own external flash with w25q128vj and nucleo F746ZG .When i try to load a bin file with stm32programmer its work only if the bin file is smaller than 128kb. Some...
I'm a complete newbe at directly programming STM and am learning using a Nucleo-l476RG board. When I try and run my code from STMCubeIDE I get errors failed to execute MI command and then "the system tried to join a drive to a directory on a joined d...
Hello,I have a project that need external loader for QSPI Flash (STM32F412G-Disco board).I'm using Visual Studio Code to write code and build the project. It work fine and i can load it with STM32CubeProgrammer.For other project, without External Loa...
Hello, I'm trying to enter the boot mode of STM32G031 with SW.the STM32G031 is connected to the STM32F4 board through UART communication and I can only set the BOOT0 pin high when connected to STM32F4' GPIO. as the RM0444 section 2.5 indicates, the b...
