Ask questions and find answers on connectivity ICs, focusing on protocols and I2C challenges on STM32 Nucleo boards and BlueNRG products.
Hey!do you have any idea for the precise indoor location of the object?Area about 30m^2, presision must be better than 0.5m.I was tested BLE trilateration, but it doesnt work due to hight freq- interferences, reflections and signal blocking is too st...
Hello,I am doing a project in which I have to receive bytes via SPI from a U-Blox GNSS receiver, specifically the NEO-M9N. I am using the STM32F0308 Discovery development board.For the NEO-M9N to constantly send information, it must receive a continu...
Hello there. Just bought an STEVAL-IDB011V1 for a small beacon pet-project. I dont have Keil or IAR IDE's so I choose a Wise Studio for programming and debugging. I've found that almost every BLE example in STSW-BNRGLP-DK has a Wise Studio project fi...
Hey,Im using the STEVAL-BCN002V1 Along with a nucleo board connected to it.i've imported the example projects into trustudio as i couldnt get them working in stm32ide.The problem im having is im unsure on the process to setup the debugging (after bui...
I want to know whether the chip hosted mode or host less mode
Hello,I can't find any example code of flash write or read using LL_drivers, only HAL drivers. I work with Blue NRG and I do have rf_drivers_ll_flash.c with functions that looks like those in rf_drivers_hal_flash.c. But I can't make flash working wit...
I bet mostly everyone who's had their hands on a Nucleo board and an S2LP addon board encountered the lack of support for the CubeIDE integration.So my question is: did anyone get the S2LP-DK or S2LP-SigFox-DK demo projects working with CubeIDE or do...
Hello,I have two custom boards with S2LP cut 3.0, with the same program, but one S2LP can't go in Rx or Tx mode. I tried S2LPPacketHandlerSetTxMode( PN9_TX_MODE ); S2LPCmdStrobeTx(); while(1);I checked the S2LP status ( MC_STATE ), its READY before a...
Hi, I have two S2- LP modul ( Radiocontrolli ) and I would like to test these but I can't start the communication. I use Microchip microcontrollers, the SPI communication is working, TX command OK, I get the nIRQ on GPIO1 ( TX data sent ) , and get ...
