Ask questions on STM32CubeProgrammer and find answers on device detection, connection failure, programming issues, and more.
Major change in SigningTool for STM32N6 in STM32CubeProgrammer v2.21.0 This release, we decided to change signing tool behavior to not automatically align the payload to 0x400 with padding bytes, since this is not necessary for other STM32 series. T...
We are pleased to announce that STM32CubeProgrammer 2.21 is available What is new in 2.21: • Support for the STM32WL3Rxx microcontrollers: – Internal memory programming – Option byte and OTP programming – PKCS#11 – Firmw...
Hi, after doing a full chip erase over a device with a STM32F103, it's impossible to download a new version over DFU with the STM32CubeProgrammer. After I press connect it shows up corrupted data on the Manuf. ID, Product ID and Serial Number paramet...
I have two stm32f429 Discovery boards. I programmed one of the board using cube ide; the output of which was as expected. Then using cube programmer I read and saved the bin file from that board. Using that bin file I programmed my another board whic...
I'm trying to configure BOR using STM32CubeProgrammer but I can't locate it on Option Byte. Even if I refer to RM0091 manual there's no section about BOR levels.
Dear STMicroelectronics Support Team,I am experiencing a persistent and frustrating issue with STM32CubeProgrammer on my Windows 10 system, where the top menu bar (File, Edit, Options, Help, etc.) is completely missing when the application launches. ...
I am contacting you to report and request assistance with a recurring issue I am facing while working with the STM32G071CBT6TR microcontroller. I am experiencing problems with the bootloader during UART-based firmware uploads.The microcontroller prog...
Hello,I have been trying to flash firmware from one MCU to another MCU, and everything until actually jumping to the memory address where the firmware has been flashed to is working so far.Here's what I do in my code:I have the "Application" project,...
Hello everyone,I am currently writing a GUI application with QT. The STM32CubeProgrammer API is integrated in the project. So far I was able to flash FW, use functions like massErase and execute without any problems (All these over UART). Now my MCU...
Hi,I am currently using the following microcontroller (STM32F100C8T6B) in my design. I have built my project using the STM32CubeIDE (STM32CubeIDE Version: 1.18.1). I have created the following output files (BIN, HEX, and ELF) and I was able to RUN an...
I have designed a board using the STM32U083KCU, i have programmed it once with a simple program made with STM32CubeIde that only prints "Hello\n" over USART2 on pins PA2 and PA3. I have flashed the chip over the same pins by holding the BOOT0 Pin hig...
Hello everyone,We're currently working on an external memory loader project using Keil, targeting both the Keil FLM Downloader and STM32CubeProgrammer. (We convert the .axf output to .FLM or .STLDR accordingly.)The flasher is designed to program an a...
