About Rob Ashworth

Rob Ashworth · 2024-07-05

I have a STM32H573I-DK discovery board, purchased for the purpose of getting to grips with Azure IoT.It appears however that the example does not run properly.Compiles and links OK, and I am using the Wireless plug in board as supplied, but it gets s...

Rob Ashworth · 2024-05-01

The inability to change the microcontroller in CubeIDE is causing me some real problems.This was my scenario:Needed to change the controller from a H5 family to U5.Couldn't see a way of changing this CubeIDE, so had to start a new project.This then m...

Rob Ashworth · 2024-04-10

Because there appear to be little/no stock of the STM32U535CEU (QFN Version) I'm left with a dilemma of whether to use the built in SMPS. Some documentation in another post describes how to connect up when not using it but how do you switch between ...

Rob Ashworth · 2024-03-28

Is there anywhere tog go to find out when parts that are not currently in stock will be?Some parts even though they are a new product line seem to have NEVER had any stock, and I though the covid supply issues were now sorted.Specifically at the mome...

Rob Ashworth · 2024-02-20

I have just purchased a STM32H573I-DK Discovery board, only to find it doesn't appear to recognise the ST-link V3. Is this a true problem, or just me, and is there a solution?

Rob Ashworth · 2024-07-05

Hi Aziz, are there any updates on this issue for ST-link V3 on apple silicon?

Rob Ashworth · 2024-05-02

I had forgotten about the .ioc file...Because I have created the project in CubeIDE not CubeMX, I have made this a little harder to sort out. I will try a dummy project later to see how it works out, but probably do all of the MCU reference changes ...

Rob Ashworth · 2024-05-02

Thanks, I have done that a couple of times too with usual success. Next time I have to do it I will see if I can write down the procedure!

Rob Ashworth · 2024-04-10

Thanks, that's awesome. I'm a bit lazy otherwise I would have resorted to the manual. The info is not in the data sheet as far as I can tell.I did a bit more digging myself, and found the register. Also I found where to set it in CubeIDE, which I ...

Rob Ashworth · 2024-04-10

So if I want the option for example of maybe using the SMPS how do I switch between using the LDO and the SMPS?

User statistics

User Activity

STM32H573I-DK Azure IoT example locks up

CubeIDE issue with Github and inability to change controller type

STM32U535 'Q' SMPS usage

STM32U5 QFN Availability

STlink V3 not working with MacBook M2

Re: STlink V3 not working with MacBook M2

Re: CubeIDE issue with Github and inability to change controller type

Re: CubeIDE issue with Github and inability to change controller type

Re: STM32U535 'Q' SMPS usage

Re: How do I connect the STM32's SMPS (Switched-Mode Power Supply) signals when the integrated SMPS