Interface and connectivity ICs

cancel
Showing results for 
Search instead for 
Did you mean: 

Forum Posts

How to test IPM

Posted on March 31, 2017 at 02:45I purchased IPM for my degree project with parts number: STGIPS20C60 and it is connected with the PWM and the IPM is not working . I want to test the IPM any idea  how to test if the ipm is working or not. 

Sensortile BlueNRG-MS Custom Service ACI

Posted on February 28, 2017 at 16:19Hi,I am working on Sensortile kit with the BlueNRG-MS radio.As per ST document PM0237 section 3.3, pg 55/99, following commands are used to add custom service to BLE device : //Add the service with service_uuid 12...

RADS1 by Associate II
  • 1580 Views
  • 7 replies
  • 0 kudos

Spriti1 application

Posted on March 23, 2017 at 17:03Hello everybody,I have the STEVAL-IKR001Vx evaluation kit and the SDK-2.0.1 and SDK-2.2.0. I have been trying to work with the GenericBasic_A and B. Both files compiled without any error in IAR and Keil v4. However, ...

idris by Associate II
  • 324 Views
  • 0 replies
  • 0 kudos

Spirit1

Posted on March 23, 2017 at 16:47Hello everybodI have the STEVAL-IKR002Vx developmental kits and downloaded the SDK 2.0.1 and 2.2.0. I have been working on the SDK_BasicGeneric_A and B. The code compile fine in both IAR and KeilV4. However, nothing ...

idris by Associate II
  • 287 Views
  • 0 replies
  • 0 kudos

logic output max current for ST3232C

Posted on March 19, 2017 at 00:30I'd drive an opto-isolator's LED directly from the logic output of ST3232CTR (VCC=5V). I'd set current with a serial resistor (Vcc - R - LED - 3232's output.  Output=L to light the LED up). I checked 'DocID7454 Rev 1...