It has vulnerability on OpenSSL - running on 3.1.2 , latest version online is 3.1.6 (LTS -3.0) c:\program files\stmicroelectronics\stm32cube\stm32cubeprogrammer\updater\libcrypto-3.dll CVE-2023-4807 CVSS 7.8we kindly request that you prioritize relea...
Hi folks,I have a Projekt on an STM32G431CBU. The programm runs without erros in DEBUG mode as well as in RELEASE Mode, when I flash it from the CubeIDE. For me this means the binaries are OK.But if I want to flash the ELF-Files to the MCU with Cube ...
Hello,I'm using CLI version of Cube Programmer for accessing/erasing/writing FLASH of STM32F412 MCU. The problem which I have is that I'm not able to reset board after series of action performed over DFU (using ST micro bootloader) while connected ov...
Hi. I made a custom PCB with an STM32C031 microcontroller. However, I am unable to program it because it is recognized as 0x466. The problem occurs in both STMCubeProgrammer and the IDE. I checked 2 st-links with the latest firmware. Regards.
Hi,similarly to what happened to others with previous versions of STM32CubeProgrammer, an error occurs when I proceed to download the firmware via USB connection:Error: Write failed at address: 0x800…. (address is not always the same)Error: failed to...
Hello I've problems connecting via DFU. The cubeprogrammer is trying, but never reaches the connected state. However, if I connect one time with a ST-Link device, the disconnect and switch to DFU then it works as long I do not close the CubeProgramme...
This might have already been asked in the past, is there a way to not having to press return after programming a file with (old) ST-LINK CLI Utility?I am using the command line version which works fine but before the program runs ST-LINK stop and wai...
I am developing software on Windows using STM32CubeIDE and STM32CubeProgrammer.I have a question about how to run Debug using the st-link gdb server in a CLI environment.I want to capture the results of Google Test running on the firmware via SWO out...
I work on a custom board based on stm32f446x MCU. I'm having trouble when writing to external flash using STM32CubeProgrammer. After powering on the board, I can connect and read the external memory correctly. However, when I try to write, the operat...
Hi, I got the NUCLEO-L433RC-P and just make default build and flash it but i got the data mismatch error:Error: Data mismatch found at address 0x080031A0 (byte = 0x37 instead of 0x80)any idea? 08:12:39 : STM32CubeProgrammer API v2.16.0 | Windows-64B...