Ask questions on STM32CubeProgrammer and find answers on device detection, connection failure, programming issues, and more.
We are pleased to announce that STM32CubeProgrammer 2.22 is available What is new in 2.22: Support for the STM32U3 microcontrollers with 2 Mbytes of flash memory: Internal memory programming through debug and bootloader interfacesOption bytes program...
Dear STM32CubeProgrammer Community, I hope you are all doing well. Over the past months, you may have received an email from me, either through the STM32CubeProgrammer survey or on other topics like CSAT or Raspberry Pi support. First, I would like...
Major change in SigningTool for STM32N6 in STM32CubeProgrammer v2.21.0 This release, we decided to change signing tool behavior to not automatically align the payload to 0x400 with padding bytes, since this is not necessary for other STM32 series. T...
l want to connect pcb board through stm32cubeprogrammer.But it posts pop-up like that.The error massage is "Error: Problem occured while trying to connect".And sometimes it connects well, so i can't find the reason.Could you give me some adivce to th...
I'm trying to load firmware through UART (not SWD/ST-Link) to my STM32G031F6P6 prototype board using STM32CubeProgrammer but can't get it to work (although it works fine through SWD and STM32CubeIDE). Note: BOOT0 and SWDCLK are shared on the same Pi...
Hi,I am using MB1549C devkit for STM32U5. I have enabled trust zone and created one application. Now I wanted to update firmware via native bootloader over UART. I have tried to connect it over UART2, I got read error over 0x0C00 0000 where secure fi...
When using STM32CubeProgrammer to program STM32F103VET6, it is found that using the "page erase" function will erase the first page error by mistake (erase pages 1, 3, 5). Upon inspection, it is found that the page erase data sent by STM32CubeProgram...
Platform: Windows 11 22H2 (x64)CubeProgrammer version: 2.12After updating CubeProgrammer from 2.6 to 2.12 we end up with issues where selecting sectors to erase does not work with UART connection mode. What we observed is that program sends wrong dat...
Hi, I have an ELF file modified to write to the main memory address 0x08004000 instead of 0x08000000. Please find the screenshot below and the ELF file in the attachment.But instead of writing to 0x08004000 it constantly writes to 0x08000000. Why is ...
Hi,I have acquired a new STM32G031 microcontroller that has not been previously flashed and have observed an unexpected behavior when powering up my circuit prior to the initial software upload.Upon further investigation, I discovered that multiple r...
Hi.I tried update STM32CubeProgrammer to 1.13 version through "software update" tab, but STM32CubeProgrammer says there's no update. I have 1.12 version.
Hi there, I'm starting to use the stm32cubeprogrammer sw, and don't know how to practice sending valid commands through this interface. I have located the CLI.exe but every time I click on it, the program executes and then closes. What am i doing wro...
