Where to find command tool SFMIPreparationTool_CLI.exe?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2022-07-27 8:45 AM
I am reading UM2238 User manual Rev 8, At page 18, it shows command line interface (CLI). Where can I doenload tool so I can hands on forlling the instruction?
- Labels:
-
STM32CubeProgrammer
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2022-07-27 10:39 AM
Perhaps the FULL install of the STM32 Cube Programmer Package?
Up vote any posts that you find helpful, it shows what's working..
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2022-07-28 2:01 AM
@Community member​ Thank you very much. I reinstall "STM32 Cube Programmer Package". This feature comes as a selection of “STM32 Trusted Package Creator tool�? while install
SetupSTM32CubeProgrammer_win64.exe. Could not find the command line interface tool but GUI is installed. GUI could be better.
