Hi! I'm searching a way to exit from the builtin bootloader after having successfully programmed my flash from USB. Is it possible to jump to my program in flash if I continue to hold the boot0 pin always high? I have done some attempts using STM32_P...
Dear allIf we clear the IWDG option (enable watchdog by hardware at bootup), we cannot undo this.In that case we have to use the old STM32 ST-LINK Utility tool.STM32CubeProgrammer version: v2.11.0µC: STM32G474RBT3The problem seems to be PC dependent!...
Failed to execute MI command:target remote localhost:61234Error message from debugger back end:localhost:61234: Connection timed out.
Dear allI think the description is wrong or BOOT0/BOOT1 is swapped - see attachments.If the option bytes are programmed as shown under STM32CubeProgrammer.png, the controller boots from flash.Thanks in advance,Franz
MCU STM32G473MXTCLI argument: -c port=SWD -e all -w C:\STM\Target.hexDuring connection/power interruption, the STM32_Programmer_CLI.exe return "0" as exitcode. (same exit code with programming successful result)
Hi,I'm trying to migrate an old firmware from a STM32F303 to a STM32G474.The MCU is related to an external Flash W25Q16JV.The old configuration uses the SPI bus to communicate with the external flash.So I changed the program in order to adapt the new...
CubeProgrammer under Windows (graphical Version) is working fine. CubeProgrammer with Cmd Line brings error:Output ------------------------------------------------------------------- STM32CubeProgrammer v2.10.0 ------------...
Hi all. I am using STM32CubeProgrammer with an STM32G474VET6 target system on a Windows 10 box with a USB-connected STLink module. The programmer is v2.10.0, and the STL firmware is v2J3757.My problem is that the Cube programmer doesn't seem to be ab...
Followed STM tutorial on the subject. This is custom board STM32G484 with Winbond 25q128jvsq. Memory can read, erased and written to. It passes all the tests in quad mode (4 IO lines). However Programmer reads only single line, hence rather all FF's ...
Hi, I've some problem using SMT32CubeProgrammer. i am trying to connect via uart to micro stm32g491 but i receive some error messages. 15:21:34:034 : RTS low 15:21:34:034 : DTR low 15:21:34:171 : Serial Port COM15 is successfully opened. 15:21:34:172...