Dear allI’m not able to reset RDP to level 0Custom board with STM32F732ZET6Not sure, but something goes wrong and I think the information block was erased only – without programming afterwards“The value of an option is automatically modified by first...

Dear allIf we clear the IWDG option (enable watchdog by hardware at bootup), we cannot undo this.In that case we have to use the old STM32 ST-LINK Utility tool.STM32CubeProgrammer version: v2.11.0µC: STM32G474RBT3The problem seems to be PC dependent!...

Dear allI think the description is wrong or BOOT0/BOOT1 is swapped - see attachments.If the option bytes are programmed as shown under STM32CubeProgrammer.png, the controller boots from flash.Thanks in advance,Franz

Dear allUnder windows 11 the 64 bit setup (2.11) startswith extracting the file and after that I see sometimes the busy signal, but... There are no entries in the windows event logger.I know, that windows 11 isn’t mentioned in the release notes (RN01...

Dear allI want to check flash integrity with CRC checksum – IAR workbench has built-in features to calculate and add the CRC to the firmware.Under STM32CubeIDE I use a post buildsrec_cat.exe firmware.bin -binary -stm32-l-e 0xEFFC -o firmware_withCRC....