We are pleased to announce that STM32CubeProgrammer 2.19 is available What is new in 2.19: Support for the STM32WBA6xxx microcontrollers: Internal memory programmingOption byte/OTP programmingRDP regression with passwordSFI support Support for MCE N...
Hello,There have been several similar threads but no answer from ST:https://community.st.com/t5/stm32cubeprogrammer-mcus/uninstall-stm32cubeprogrammer-ubuntu/td-p/335445https://community.st.com/t5/stm32cubeprogrammer-mcus/how-to-uninstall-stm32cubepr...
Instead of completing development of STM32CUBE Programmer - every one now need to follow some manual steps with unknown versions of firmware with many undefined startup addresses and even when all steps are completed with success - development board ...
OK so total noob here with a issue, I am trying to read from an esc/motor controller through jtag ,problem lies in the fact that iim using St link and bluepill and there connected throigh sclk sdio c9nnections.so my question is how and what to do...
Hi,I'm developing a GUI invoking STM32TrustedPackageCreator_CLI tool to generate SFI encryption key file and nonce file, but I have no idea on the command syntax, does any one can help me? thanksLuke
A write of size 294KB to STM32H7A3VGHx Internal Flash works, but a write of size 775KB does NOTBTW, same issue with STM32CubeProgrammer v2.16.0
Hi,I have a project with an external loader. When programming using ST-LinkV2 (SWD) it works perfectly with CubeIDE or the STM32Programmer CLI.When trying programming the same ELF file using USB DFU connection, I get the following message, and the pr...
good morning, i am using stm32h747i-disco board. for that when i am executing Touchgfx generated file into stm32cubeide. i am able to debug the m4 processor but not m7 processor. i am getting an error with " internal .elf file".then i did cm7 process...
Hey everyone!.I'm trying to use I2C protocol to transmit data from master to slave using i2c1 and i2c2 pins.But my rx buffer is not getting updated.I've gone through a couple of tutorials and I found out that in most of them they used two boards , so...
I managed to get the setup program to complete by running directly from the command line.The STM32CubeProgrammer app fails to run, giving the follow error trace:CubeProgrammer version: 2.15.0Path CubeProgrammer version: : /Applications/STMicroelectro...
HelloFor my project I use a stm32g491rct6 with 256k flash. STM32CubeProgrammer 2.16.0 show the block contiguos 0-255 from 8000000 to 807ffff while STM32CubeProgrammer 2.17.0 show blocks 0-63 from 8000000 to 801ffff and 65280-65343 from 8040000 to 805...
