Ask questions on STM32CubeProgrammer and find answers on device detection, connection failure, programming issues, and more.
We are pleased to announce that STM32CubeProgrammer 2.20 is available What is new in 2.20: • Support for the STM32MP21x microprocessors: – External memory programming – OTP programming – PKCS#11 – ST power management IC• ...
Hi,I have a project created in Atollic TrueStudio V9.3.0 which was until recently working without problem. Now when I try and debug the project on my target, the cube programmer crashes at the 'load' stage of the startup script.I get the following e...
Anybody have a solution to this?STM32CubeProgrammer fails to re-program Bank 2 of STM32L476RC devices (256 kB FLASH), unless the device is blank (ie: after a Mass Erase). I suspect this has to do with the sector number jumping from 63 to 256 when th...
I have an STM32H747i-Eval board, I am unable to flash/access the MCU using any of the STM32 tools like,STlink utility I get the following error when i try to connect 18:07:28 : Can not connect to target! ...
hi i am trying to make a .stldr file to be able to external load the flash ic ,the mcu is 32f746ng and the flash is MX25L51245G , i tried to take one of the examples that provide with stmprogramer and change it to my configure , but unfortally i didn...
Hi,I am trying to call the bootloader from my application, on a STM32L072. I followed posts in ST Community and other resources, but failed to do it.I tried the code given in different places as below:void BootLoaderInit(void){void (*SysMemBootJump)(...
This concerns the USB programming on on STM32F7 using the HAL libraries. The output for the USB transmission randomly goes blocked with USBD_BUSY. Nothing I have done so far has unblocked it. It would appear that this is not a new problem, as I have ...
I am using ubuntu18.04. I've installed open jdk amd javagfx. But cube prog does not run due to javagfx.properties file. I searched under /usr directories. But I couldnt find out it at all.Could anyone help me?
Hello,I am trying to use the built-in UART bootloader on an STM32H7. I have two boards: one on which the bootloader works, and one on which it cannot connect.The board on which I cannot use the bootloader reports the following error when I try to con...
Hi,I am writing a customized bootloader for STM32L072CZ (Cortex M0+) and I have an issue with performing the jumping from the bootloader to the application.My application is linked at certain address (0x800b000) and I want to jump to this address fro...
I used STM32CubeProgrammer，And Set Chip Read Protection（RDP:0xCC），Now The Chip can not be connect By JLINK STLINK either Usart�?is there some method to reset the protection level？the problem had be solved，detail below：Level 2: No debugIn this level,...
