Ask questions on STM32CubeProgrammer and find answers on device detection, connection failure, programming issues, and more.
We are pleased to announce that STM32CubeProgrammer 2.20 is available What is new in 2.20: • Support for the STM32MP21x microprocessors: – External memory programming – OTP programming – PKCS#11 – ST power management IC• ...
I'm trying to use STM32CubeProgrammer on a Ubuntu system to read and eventually write the flash on my STM32F030 device via an ST-Link. However when I click the 'Read' button, after connecting to the ST-Link I get two errors: Error: Unable to list su...
Hello, I'm having some issues with an STM32L071RB. I'm unable to read from memory address 0x08020000 onwards because it's supposed to be read/write-protected. I had similar results on STM32CubeProgrammer and via the I2C bootloader, which are as follo...
I try to implement the use of the CubeProgrammer_API.dll in wendev, and it's clearly not design for...1) problem, is struct size, du to alignment... this can be solve using some dummy byte(s)...Main problem not solve at the moment is the call of "rea...
Hi All,I have STM32H747I-DISCO board with a built-in STLink-V3E. I am trying to falsh the MCU, but no matter what I do, I cannot get STM32CubeProgrammer 2.5.0 to recognise the board.I plug the board into Win10 PC via a micro-USB cable in the ST-Link-...
Hi all, I have been looking for sometime now but I can not seem to find a link to a bug tracking system where I can report issues that I am facing with STM32CubeProgrammer or Micro-controller. The community has been helpful but it would be good to ha...
STM32CubeProgrammer not clearing the Option Bytes on STM32H7B3i-DK. I can not load any code.Is it possible to clear these bytes with STM32CubeProgrammer and if so how? Below is the error that I am getting.13:58:53 : Time elapsed during the read opera...
HiWe are Using a STM32H755IIT6 for the aplicatin. Now we are using USART1 on PA9,PA10 as Debug and Boot loader Interface. If we are in Normal Operation and the GPIO are configured we are fine and everything works as expected. As soon as we enter the ...
I have few devices With STM32F0xx which are connected via usb to linux hosts. In order to get necessary functionality I have to swap their firmware. Given that they are connected to linux I used first ‘dfu-util’. While tool itself completes process d...
Hello guys,Recently, my ST Discovery F407 board was working just fine, until I received the following error in a txt. File: the interface firmware failed to reset/halt the target mcu.I have updated its frimware to 2.37.26, but the problem is stil...
Hi,Not sure what I am doing wrong but when I program my STM32H7B3I-DK board with STM32CubeProgrammer, all seems fine, the application start to run and everything is okay.The problem occurs when I click the Disconnect button and later then try to Conn...
