I'm trying to get PySide6 and some common Python packages on my STM32MP257. "apt-get install python3-PySide6" doesn't work. I also tried to install the PySide6 package using pip3, which installed successfully, but gave me the error "ImportError: libX...
Hi,I'm trying to add external out-of-tree module in developer package. (following wiki)After following wiki, I got error message in board(STM32MP157F-DK2) like this. modprobe: ERROR: could not insert 'kernel_module_example': Exec format error There w...
Hi,I'm aware of the manual from https://wiki.st.com/stm32mpu/wiki/Getting_started/STM32MP1_boards/STM32MP157x-DK2/Let%27s_start/Populate_the_target_and_boot_the_image but it does not solve my problem as it seems to be completely faulty:different to t...
Hello,I am trying to get the X-LINUX-ISP expansion installed onto a MP257-DK board. I can not connect the board to a network at this time, so I have resorted to trying to build a distribution following the instructions here.When I run bitbake, patche...
Hello. I am struggling to get my codec to work. I am using MAX9860 codec.The MAX9860 driver fails during probing, since the MCLK rate is registered as 0.I get the following error:[ 15.465445] max9860 1-0020: Bad mclk 0Hz (needs 10MHz - 60MHz)[ 15.481...
Hello We are Working on STM32MP257F-DK Board using Buildroot. We have built buildroot using the below link as referral.https://bootlin.com/blog/updated-buildroot-support-for-stm32mp1-and-stm32mp2-platforms-st-bsp-v6-0/While verifying USB , we observe...
Hi,I'm trying to write a simple firmware for M33 core to test PWM outputs with TIM8 on STM32MP257FEV-1 board. It is possible to generate output for channels TIM8_CH1, TIM8_CH3 and TIM8_CH4, but as soon as I try to generate complementary outputs (TIM8...
Hello!Please tell me how to create a basic C/C++ BareMetal project in CubeIDE for the A35 core of the STM32MP257F-DK board?When I create a project for STM32MP1 I have a choice to create a "BareMetal" project or a Linux project.Unfortunately, when I c...
HelloWe are Working on STM32MP257F-DK Board.We would greatly appreciate your help if you could help us with the following doubts:We Would like to How to disable ON-Board ST-link and Set it to J-LINK ModeWe want to Check Ethernet using build root in ...
I am new to building images using Yocto. I am working with an STM32MPU157F, which comes with OpenSTLinux by default. The default image includes Python 3.12.4, but I also need to have Python 3.11.5 available on the image. My end goal is to have both P...