I cannot get the QSPI NOR-Flash to work on my custom board using an STM32MP153CA + Adesto AT25SF128 NOR flash in U-BOOT. I'm working with 5-10-dunfell-mp1-21-11-17 files included on the 3.1.0 ecosystem.The schematic section is shown below:Is not tha...
Hi,I'm working the stm32mp157c som and trying to boot external quad spi flash (cypress S25HL512T). I added this to dts. &qspi { pinctrl-names = "default", "sleep"; pinctrl-0 = <&quadspi_pins_mx>; pinctrl-1 = <&quadspi_sleep_pins_mx>; status = "...
Hi,we are working on a sensor data reading application based on your logic analyzer example project. But in our use case the data are sampled on a FPGA connected via QSPI. We have hard realtime requirements (far below 1ms) of reading the data and tra...
Hello again dark electronics wizards.I've been looking for some documentation about how to use an external flash memory with my stm32 designs.Is there any magic way to do this? Or could anyome point me to the right way?My goal is to add a qspi contro...
STM32MP157DAB1, WINBOND QSPI memory attached to default pins.How to program first stage bootloader trough DFU mode? Boot pins=000STM32CuneProgrammer says:15:11:45:986 : failed to read the requested memory content15:11:46:788 : failed to read the requ...
I want to use a Winbond W25M02Gxx 256MByte (2x1Gbit) on MP157 QSPI1 port. It seems that the boot mode supports the use of Serial NAND Flash.Anyone tried this?
Hello everyone, I'm curently working on a custom STM32MP1 board with a QSPI Nor flash. The NOR Flash seems to work perfectly in Uboot Basic after the modification we have done. The Data are MD5 checked and the SPL is at address 0x0 of the NOR Flash...
Posted on May 05, 2016 at 13:35It is a pity that ST hasn't released anything to program these memories under Linux, so I have developed a little utility to program STM32F7-discovery's QSPI Flash Memory.You can find it on my git repo:http://noosrequi...