I used this post https://community.st.com/t5/stm32-mpus-products/stm32mp151aac-custom-board-kernel-not-starting/td-p/587192 to figure out how to add interrupts to pmic and got my board to finally boot into Linux. I then added my ethernet to the dts ...
I am trying to enable some GPIO as external interrupts and have run the GPIO example where the user button is set as an interrupt. Is there any resources that show what GPIO can be used as external interrupts? For example, I would like to set one of ...
Hi,Section "4.3.11 NVIC register map" states that the base address of the main NVIC register block is 0xE000E100 and NVIC_ISERx registers starts at offset 0x100 (Table 49. NVIC register map and reset values). The same offset is given in section "4.3....