I have tried to build my own OpenSTLinux by using the SDK and the sources, without sucess. I have been trying to compile for 2 weeks from now and I'm not very pleased over the wiki of ST32MP.Anyway. I have to show a bug. I cannot build an OpenSTLinux...
I have made my own STM32MP1 board with the STM32MP151AAC3 processor. Right now I'm faceing issues with the software STM32CubeProgrammer and I don't know why this happens.My goal is to flash the eMMC via the UBS OTG. I have SDIO2 as eMMC by the way.Wh...
I am working on building a Yocto-based Linux distribution for the STM32MP157D SoC. I have already set up the process to build the Linux image successfully. However, I need guidance on the following:Deploying Firmware on M4 CoreWhat is the correct pro...
Dear community,I'm currently having a problem setting up an OPCUA client. Using the open62541 package, I was able to connect to an OPCUA server created in Node-Red. I was able to both read and write to the server's addresses. The connection was made ...
Hi I am working on a custom board based on STM32MP157A . For USBH_EHCI:In USBH_EHCI_HCCPARAMS register there is a bit called "SFAC" is mentioned in reference manual(RM0436) .Could you please tell us what is the meaning and functionality of the bi...
I want to enable input capture functionality on our stm32mp157c based system. I am using Timer 1 channel 4 for the same and have made the necessary additions in the device tree as follows: &dma1{ status = "okay"; /* USER CODE BEGIN dma1 */ s...
Hi,Section "4.3.11 NVIC register map" states that the base address of the main NVIC register block is 0xE000E100 and NVIC_ISERx registers starts at offset 0x100 (Table 49. NVIC register map and reset values). The same offset is given in section "4.3....